Wst 49.10 - T10 Corr

A fluidized-pellet-bed separator with movable sludge hoppers was applied in pilot scale for the separation and thickening of activated sludge mixture liquid. Under the condition of suspension SS around 4,000 mg/L, polymer (CJX103, cationic, MW 5 × 106) dose at a dry solid ratio of 0.003 and upward flow rate at 5.4 m/hr, the fluidized pellet bed performed solid/liquid separation and sludge thickening well. The SS concentration of the treated water was about 5 mg/L on average and the moisture content of the sludge after screening for 5 min was less than 94%, which is much lower than that after conventional settling and thickening and easy to be finally disposed. At a higher upward flow rate of 7.2 m/hr, similar results could also be obtained but higher polymer dose (solid ratio of 0.004) was required. The morphological characteristics and density–size relationship of the granular particles formed in the fluidized pellet bed were also investigated by image analysis and settling velocity measurement of individual particles. The two-dimensional fractal dimension was evaluated to be 1.6–1.8, showing a good quasi-spherical morphology of the granular particles with their density much higher than the conventional flocs. The results of the pilot study indicate a possible way to innovate the conventional secondary settling and gravitational thickening processes for solid/liquid separation and sludge handling, especially for small scale wastewater treatment plants to reach the goal of space saving and higher treatment efficiency.