Electromechanical characterizations of MEMS based energy harvesters by harmonic sampling analysis method
نویسندگان
چکیده
Abstract This paper presents a new and accurate experimental method based on electrical harmonic distortion analysis to determine mechanical characteristics (resonant frequency) of MEMS devices used in widespread applications as in energy scavenging, cantilever-based microsystems for gas sensing and atomic force microscopy or in any kind of MEMS resonators. Resonant frequencies ranging from 0.8 kHz to 5 kHz of electrostatic actuated MEMS-based harvesters have been measured by this technique with an uncertainty as low as a few parts in 10 constituting an outstanding result compared to the other methods.
منابع مشابه
Design and Simulation of a Fluidic Micro-Bio-Sensor Based on Resonator Array
In this paper, a fluidic biosensor with possibility to fabricate by Micro-Electro-Mechanical Systems (MEMS) technology is proposed for biomedical mass detection and lab-on-chip applications. This is designed by electromechanical coupling of harmonic micromechanical resonators with harmonic springers as a mechanical resonator array. It can disperse mechanical wave along the array by electrostati...
متن کاملComprehensive Electromechanical Analysis of MEMS Variable Gap Capacitors
This paper presents a comprehensive case study on electro-mechanical analysis of MEMS[1] variable capacitors. Using the fundamental mechanical and electrical equations, static and dynamic behaviors of the device are studied. The analysis is done for three different modes, namely: dc (static mode), small signal ac and large signal regime. A complete set of equations defining dynamic behavior of ...
متن کاملStudying piezoelastic and piezomagnetoelastic configurations for different excitation frequencies in MEMS energy harvesters
Typically two configurations are used for energy harvesting with different advantages: piezoelastic and piezomagnetoelastic. Best performance of the piezoelastic configuration is when the excitation frequency is close to the resonance frequency. If the input frequency slightly deviates from the natural frequency, the generated power is severely decreased. To tackle the problem, the piezomagneto...
متن کاملA Distributed Parameter Electromechanical Model for Cantilevered Piezoelectric Energy Harvesters
Cantilevered beams with piezoceramic layers have been frequently used as piezoelectric vibration energy harvesters in the past five years. The literature includes several single degree-of-freedom models, a few approximate distributed parameter models and even some incorrect approaches for predicting the electromechanical behavior of these harvesters. In this paper, we present the exact analytic...
متن کاملA Review of MEMS Based Piezoelectric Energy Harvester for Low Frequency Applications
This paper presents a review of MEMS based piezoelectric energy harvesting for low frequency and low power applications. An introduction to MEMS and its components along with the concept of energy harvesting is presented. The paper also presents a device configuration of cantilever based basic components of MEMS energy harvesters, i.e. unimorph, bimorph. Results of different designs for MEMS en...
متن کامل