Effect of hydrogen bonding on the compressive strength of dihydroxypoly(p-phenylenebenzobisoxazole) fibers.

نویسندگان

  • Tao Zhang
  • Junhong Jin
  • Shenglin Yang
  • Guang Li
  • Jianming Jiang
چکیده

By the introduction of binary hydroxyl groups into poly(p-phenylenebenzoxazole) (PBO) macromolecular chains, a series of dihydroxypoly(p-phenylenebenzobisoxazole) (DHPBO) chains were prepared, and the effect of the hydroxyl groups on the axial compression property of DHPBO fibers was investigated. The variable-temperature Fourier transform infrared spectrum proved the existence of hydrogen bonds in DHPBO chains. Furthermore, the axial compression bending test showed that the introduction of hydroxyl groups into macromolecular chains apparently improved the compression resistance property of DHPBO fibers. Finally, a proposed arrangement of the hydrogen bonding in DHPBO fibers is presented.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effect of Polypropylene Fibers on Strength and Thermal Resistance of Concrete

In this paper, the effect of Polypropylene Fibers added to concrete on strength and thermal resistance of high strength concrete has been investigated. Therefore, five tests have been carried out to reach this goal which it includes; effect of weight percent of polypropylene fibers on mechanical properties of concrete, effect of fiber’s length on the strength of high strength concrete, effect o...

متن کامل

Synthesis and Properties of Poly[p-(2,5-dihydroxy)-phenylenebenzobisoxazole] Fiber

The novel polymer poly[p-(2,5-dihydroxy)-phenylenebenzobisoxazole] (PBOH) fiber was synthesized in the presence of 2,5-dihydroxyterephthalicacid (DHTA) and 4,6-diamino-1,3-benzenediol in poly(phosphoric acid) (PPA) using typical polycondensation conditions. The crystalline solutions of liquid PBOH in PPA were spun into fibers using dry-jet wet spinning. Furthermore, the thermostability and mech...

متن کامل

Effects of Waste Fibers Stabilizers on the Draindown and Moisture Damage Sensitivity Properties of SMA Mixtures

Waste fibers produced from manufacturing processes are a byproduct commonly deposited in storing yards and/or landfills and thus results in many serious environmental problems in Iran. If these waste materials could be advantageously put to practical use in any application, it would reduce the burden on the environment and landfills. This paper compares the performance of the stone matrix aspha...

متن کامل

Influence of Nano-silica and Polypropylene Fibers on Bond Strength of Reinforcement and Structural Lightweight Concrete (RESEARCH NOTE)

In this study, first by surveythe parameters affecting the compressive strength, such as water to cement ratio, cementgrade, silica fume to cement percentage, and the various ratios oflight weight aggregate LECA, to total aggregate, Taguchi method is used, to test 9 mix designsobtained the mix design optimization. Since lightweight concrete is brittle like normal concrete, to resolve this probl...

متن کامل

Strength and Toughness of Reinforced Concrete with Coated Steel Fibers

The effect of zinc phosphate (ZP) and zinc calcium phosphate (ZCP) coatings on the reinforcing mechanisms of smooth steel fiber in cementitious matrix have been studied. The results of pull out tests illustrated that by coating smooth steel fiber the pull-out load may be increased up to 100%. The effect of zinc phosphate coating on interface bonding was more than zinc-calcium phosphate coating....

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • ACS applied materials & interfaces

دوره 1 10  شماره 

صفحات  -

تاریخ انتشار 2009