Study of Equilibrium and Mass Transfer of Co- Extraction of Different Mineral Acids with Iron(III) from Aqueous Solution by Tri-n-Butyl Phosphate Using Liquid Membrane

نویسندگان

  • Diptendu Das
  • Vikas Kumar Rahi
  • V. A. Juvekar
  • R. Bhattacharya
چکیده

Extraction of Fe(III) from aqueous solution using Trin-butyl Phosphate (TBP) as carrier needs a highly acidic medium (>6N) as it favours formation of chelating complex FeCl3.TBP. Similarly, stripping of Iron(III) from loaded organic solvents requires neutral pH or alkaline medium to dissociate the same complex. It is observed that TBP co-extracts acids along with metal, which causes reversal of driving force of extraction and iron(III) is re-extracted back from the strip phase into the feed phase during Liquid Emulsion Membrane (LEM) pertraction. Therefore, rate of extraction of different mineral acids (HCl, HNO3, H2SO4) using TBP with and without presence of metal Fe(III) was examined. It is revealed that in presence of metal acid extraction is enhanced. Determination of mass transfer coefficient of both acid and metal extraction was performed by using Bulk Liquid Membrane (BLM). The average mass transfer coefficient was obtained by fitting the derived model equation with experimentally obtained data. The mass transfer coefficient of the mineral acid extraction is in the order of kHNO3 = 3.3x10m/s > kHCl = 6.05x10m/s > kH2SO4 = 1.85x10m/s. The distribution equilibria of the above mentioned acids between aqueous feed solution and a solution of tri-n-butyl-phosphate (TBP) in organic solvents have been investigated. The stoichiometry of acid extraction reveals the formation of TBP.2HCl, HNO3.2TBP, and TBP.H2SO4 complexes. Moreover, extraction of Iron(III) by TBP in HCl aqueous solution forms complex FeCl3.TBP.2HCl while in HNO3 medium forms complex 3FeCl3.TBP.2HNO3 Keywords—Bulk Liquid Membrane (BLM) Transport, Iron(III) extraction, Tri-n-butyl Phosphate, Mass Transfer coefficient.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Separation of methacrylic acid from aqueous phase using quaternary amine

The feasibility of extractive reaction of methacrylic acid from aqueous solution using a quaternary amine, tri–octyl methyl ammonium chloride (TOMAC) as an extractant, was studied. The diluents chosen in the present work belong to different chemical classes, n–butyl acetate, carbon tetrachloride, isoamyl alcohol, methyl isobutyl ketone, and toluene. The effect of initial acid concentration in t...

متن کامل

Equilibrium Study on Reactive Extraction of Acetic Acid with Tri-n-butyl Phosphate in N-hexane

Extraction of carboxylic acids from dilute aqueous solution using traditional solvents such as ketones, alcohols, ethers, and ester is inefficient because the distribution ratio is rather low. Reactive extraction which exploits reversible chemical complexation is an effective separation process for extraction of carboxylic acids from aqueous streams such as fermentation broths and wastewaters. ...

متن کامل

Separation of Carboxylic Acids from Aqueous Solutions using Hollow Fiber Membrane Contactors

Separation of formic, acetic, and propionic acids from the aqueous stream using membrane solvent extraction has been studied using three different membrane contactors made of polysulfone (PS), polyethersulfone (PES), and polyvinylidene fluoride (PVDF) using two different solvents; including ethyl acetate (EA) and diisopropyl ether (DIPE). The efciency of the membrane and e...

متن کامل

Optimization Extraction of Terbium by Supported Liquid Membrane Using D2EHPA and TOPO

The extraction of Terbium (III)from aqueous nitrate solutions with a supported liquid membrane was investigated using a mixture of di-(2-ethylhexyl phosphoric acid (D2EHPA) and tri-octyl phosphine oxide (TOPO) with a molar ratio 1/0.4. The Hydrophobic Polyvinylidene Fluoride (PVDF) membrane was used as solid support. The sorption process followed pseudo-second-o...

متن کامل

Extractive Properties of Tri-n-octylphosphine Oxide Towards Thorium (IV) and Europium (III) Ions in Aqueous Nitrate Media

Phosphoryl containing ligand tri-n-octylphosphine oxide (TOPO) in dichloromethane has been used as an extracting agent for tetravalent thorium and trivalent europium ions from their 1 M sodium nitrates. The equilibrium data reveal that both ions are extracted as the complexes at 1:3 metal/ligand ratio. The values of conditional extraction equilibrium constant (Kex) show the superior extract...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2013