InGaN-based photoanode with ZnO nanowires for water splitting

نویسندگان

  • Junjie Kang
  • Vinhquang Dang
  • Hongjian Li
  • Sungjin Moon
  • Panpan Li
  • Yangdoo Kim
  • Chaehyun Kim
  • Hakjong Choi
  • Zhiqiang Liu
  • Heon Lee
چکیده

The water splitting properties of InGaN photoanodes equipped with ZnO nanowires were examined in this study. Over the solar spectrum range, the absorbance exhibited a remarkable increase due to the enhanced light absorption caused by the ZnO nanowires. By varying the ZnO nanowires length, the photo-to-current density of photoanodes was increased from 0.017 to 0.205 mA/cm2 at 1.23 V versus reversible hydrogen electrode. Consequently, the incident-photon-to-current efficiency was increased by a factor of 5.5 as the ZnO nanowires growth time increased from 2 to 4 h. The results of this research demonstrate the importance of light absorbance and the surface reaction sites of photoanodes on energy harvesting.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Si/InGaN core/shell hierarchical nanowire arrays and their photoelectrochemical properties.

Three-dimensional hierarchical nanostructures were synthesized by the halide chemical vapor deposition of InGaN nanowires on Si wire arrays. Single phase InGaN nanowires grew vertically on the sidewalls of Si wires and acted as a high surface area photoanode for solar water splitting. Electrochemical measurements showed that the photocurrent density with hierarchical Si/InGaN nanowire arrays in...

متن کامل

Au@CdS Core–Shell Nanoparticles‐Modified ZnO Nanowires Photoanode for Efficient Photoelectrochemical Water Splitting

Hydrogen production from water splitting using solar energy based on photoelectrochemical (PEC) cells has attracted increasing attention because it leaves less of a carbon footprint and has economic superiority of solar and hydrogen energy. Oxide semiconductors such as ZnO possessing high stability against photocorrosion in hole scavenger systems have been widely used to build photoanodes of PE...

متن کامل

Earth-Abundant Oxygen Evolution Catalysts Coupled onto ZnO Nanowire Arrays for Efficient Photoelectrochemical Water Cleavage

ZnO has long been considered as a model UV-driven photoanode for photoelectrochemical water splitting, but its performance has been limited by fast charge-carrier recombination, extremely poor stability in aqueous solution, and slow kinetics of water oxidation. These issues were addressed by applying a strategy of optimization and passivation of hydrothermally grown 1D ZnO nanowire arrays. The ...

متن کامل

Photoelectrochemical performance of N-doped ZnO branched nanowire photoanodes

A ZnO branched-nanowire (BNW) photoanode was doped with N for use in a photoelectrochemical cell (PEC) to generate H2 from water splitting. First, ZnO BNWs were synthesized by chemical bath deposition method. Two experimental methods were used for N-doping: the time-controlled direct-current glow discharge plasma (DCGDP) and the DC magnetron plasma (DCMP) methods, to optimize N-doping of the NW...

متن کامل

Hierarchically assembled ZnO nanoparticles on high diffusion coefficient ZnO nanowire arrays for high efficiency dye-sensitized solar cells.

In this study, ZnO nanoparticles (ZnO NPs) were conformally covered on the surfaces of ZnO nanowires (ZnO NWs) with high diffusion coefficient (1.2 × 10(-2) cm(2) s(-1)) to make a composite photoanode. By using N719 to sensitize the composite photoanode, the conversion efficiency can reach 7.14%.

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 3  شماره 

صفحات  -

تاریخ انتشار 2016