Aiaa 2002–0413 Active Flow Control of Separation on a Wing with Oscillatory Camber
نویسندگان
چکیده
منابع مشابه
Aiaa 2001–0293 Active Control of Separation on a Wing with Conformal Camber
A preliminary investigation of a wing with a conformal camber is discussed. The wing uses an adaptive actuator mounted internally to alter the shape of the suction surface which results in a change in the effective camber by increasing the maximum thickness and moving the location of maximum thickness aft. Since the actuator motion can be altered continuously, this allows the wing shape to be e...
متن کاملEnabling Flow Control Technology for Low Speed UAVs
This paper discusses several technologies currently being investigated for use on low speed UAVs. This includes adaptive wing technology that controls separation via active changes in the camber, use of large scale surface roughness to control separation, plasma actuators to control stall and enhance lift, and inflatable wings that can be tailored using wing warping. Results from wind tunnel an...
متن کاملEXPERIMENTAL INVESTIGATION OF DRAG REDUCTION ON AHMED MODEL USING A COMBINATION OF ACTIVE FLOW CONTROL METHODS
Aerodynamic drag is an important factor in vehicles fuel consumption. Pressure drag which is the main component of total drag is a result of boundary layer separation from vehicle surface. Flow control methods are applied to avoid or at least delay separation. Depending upon whether these methods consume energy to control the flow or not, they are called active or passive control methods. In th...
متن کاملAn Integrated Trim and Structural Design Process for Active Aeroelastic Wing Technology
A new method for concurrent trim and structural optimization of Active Aeroelastic Wing technology is presented. The new process treats trim optimization and structural optimization as an integrated problem in the same mathematical formulation, in which control surface gear ratios are included as design variables in a standard structural optimization algorithm. This new approach is in contrast ...
متن کاملThe effect of flow parameters on mixing degree of a three dimensional rhombus micromixer with obstacles in the middle of the mixing channel using oscillatory inlet velocities
The previous studies of authors on passive micromixers indicated that the micromixers dividing the flow to several layers, such as rhombus micromixers and micromixers with obstacles in the middle of the mixing channel, have higher mixing degree than other types. Also, using of oscillatory inlet velocities is an active method to enhance the mixing efficiency of micromixers. Therefore, in this st...
متن کامل