A pr 1 99 8 Proper initial conditions for the lubrication model of the flow of a thin film of fluid
نویسندگان
چکیده
A lubrication model describes the dynamics of a thin layer of fluid spreading over a solid substrate. But to make forecasts we need to supply correct initial conditions to the model. Remarkably, the initial fluid thickness is not the correct initial thickness for the lubrication model. Theory recently developed in [12, 14] provides the correct projection of initial conditions onto a model of a dynamical system. The correct projection is determined by requiring that the model's solution exponentially quickly approaches that of the actual fluid dynamics. For lubrication we show that although the initial free surface shape contributes the most to the model's initial conditions, the initial velocity field is also an influence. The projection also gives a rationale for incorporating miscellaneous small forcing effects into the lubrication model; gravitational forcing is given as one example.
منابع مشابه
A normal form of thin fluid film equations provides initial conditions
We use dynamical systems theory to construct the normal form of the Navier–Stokes equations for the flow of a thin layer of fluid upon a solid substrate. The normal form equations illuminate the fluid dynamics by decoupling the long-term flow of interest from the rapid viscous decay of the transient shear modes. The normal form clearly shows the centre manifold of the lubrication model and show...
متن کاملProcess Optimization of Deposition Conditions for Low Temperature Thin Film Insulators used in Thin Film Transistors Displays
Deposition process for thin insulator used in polysilicon gate dielectric of thin film transistors are optimized. Silane and N2O plasma are used to form SiO2 layers at temperatures below 150 ºC. The deposition conditions as well as system operating parameters such as pressure, temperature, gas flow ratios, total flow rate and plasma power are also studied and their effects are discussed. The p...
متن کاملFlow Field Characteristics of an Aerospike Nozzle Using Different Turbulence Models
To improve the calculation of the flow properties of an aerospike nozzle, different turbulence models were investigated in this study. The primary shape of the nozzle plug is determined through utilizing an approximate method. The flow field is, then, simulated using the Navier-Stokes equations for compressible flows. The commercial computational fluid dynamics code Fluent is used to simulate t...
متن کاملPhysical Modeling of Steel Delivery during Thin Slab Continuous Casting
A full scale physical model of a thin slab caster with a four-hole design submerged entry nozzle (SEN) was constructed. On the basis of the dimensionless Reynolds and Froude similitude criteria, the fluid flow in a full-scale model is similar to that of the actual system and, hence, the data obtained from the water model can be applied to the actual system. In order to determine the optimum ope...
متن کاملInvestigations on Cold Rolling of Strip in Attendance of Hydrodynamic Lubrication
In this paper an analytical model for cold rolling of strip has been described. This model is developed based on the slab method of analysis and the hydrodynamic lubrication. The characteristics of rolling are obtained from the equations of equilibrium and the plate was allowed to strain harden assuming that the lubricant behaves as a Newtonian fluid. The shear stress to the plate is obtained b...
متن کامل