Gas turbine diagnostic system

The creation of the systems models is very actual at present time, because it allow to simulate the work of some complex equipment without any additional spends. The given model of gas turbine is allowed to test and optimize the software for gas turbine automation systems, study station personal, like operators and engineers and will be useful for diagnostics and prediction tasks to analyze the efficiency of the gas turbine. This software system is designed for simulation and control of the gas turbine units, to protect and perform simulation of automatic control functions of the Gas Turbine Compressor Unit and of the Compressor Station’s stationary equipment, to adjust and stabilize the process variables in different operating modes of the GTCU. The main functions of the system is: Mathematical Modeling. During the process of building a mathematical model of the technological process all possible process variables are taken into consideration, because the adequacy of the model to its real object is an important critical factor in the successful solving of diagnostic and optimization tasks. The mathematical model of the technological process reflects its main functionality and dependency between the most essential characteristics of the process and its key parameters and entrance conditions. Forecasting. On the basis of the simulation model the system creates the optimal schedule of functioning of the equipment according to a production plan. Personnel Training. This software simulation model can be used to familiarize the compressor station personnel with the main principles of operation of the microprocessor based ACS GTCU, and also can be used to train CS’ operational personnel to work with this type of ACS. The system represents the modular software environment, where can be simulated the model of the GTCU to perform the main functions of ACS in the realtime (to run and control Turbine, to load GTCU in the mode “Ring” or “Trunk line”), and also control the auxiliary equipment (pumps, fans, etc.) Software Testing By carrying out the test procedure on the simulation software the ACS GTCU control program can be debugged rapidly. In the first place, the performance of the control algorithm of the GTCU, for both the main and the auxiliary equipment, is verified. Moreover, all functionality of the SCADA system can be tested. The modular simulation software has a three-level hierarchy structure (Figure 1): − High Level – this level of software is based on SCADA WinCC SIEMENS, and it is used to control, visualize and archive the information (Figure 2).