Refining grain structure and porosity of an aluminium alloy with intensive melt shearing
نویسندگان
چکیده
Intensive melt shearing was achieved using a twin-screw machine to condition an aluminium alloy prior to solidification. The results show that intensive melt shearing has a significant grain-refining effect. In addition, the intensive melt shearing reduces both the volume fraction and the size of porosity. It can reduce the density index from 10.50% to 2.87% and the average size of porosity in the samples solidified under partial vacuum from around 1 mm to 100 μm.
منابع مشابه
EFFECT OF REFINING PROCESS ON POROSITY AND MECHANICAL PROPERTIES OF HIGH PRESSURE AL-SI ALLOY DIE CASTINGS
Abstract: This study presents the research results of effect that refining process has on porosity and mechanical properties of high pressure die castings made of AlSi12S alloy. The operation of refining was carried out in a melting furnace with the use of an FDU Mini Degasser. Mechanical properties (UTS, YS, Elongation, Brinell Hardness) were assessed on samples taken from high pressure die ca...
متن کاملMicrostructure and Grain Refining Performance of a New Al-Ti-C Master Alloy (RESEARCH NOTE)
Control of microstructure parameters that affecting the Al-Ti-C master alloys grain refining efficiency is leading to improve the aluminum grain refinement. This study was an attempt to produce Al-Ti-C master alloys that provide these controlling factors with relying on the solute effect theory. The produced master alloys were examined by using scanning electron microscopy (SEM), energy-dispers...
متن کاملInfluence of Zirconium on the Grain Refinement of Al 6063 alloy
The influence of zirconium on the grain refinement of Al 6063 alloy has been experimentally investigated. The microstructure and macrostructure of the refined alloy were investigated. The experimental results reveal that, the coarse dendrites in the microstructure of the alloy are effectively refined with the addition of zirconium to the melt prior to solidification. Grains of Al 6063 alloy can...
متن کاملOpen Archive Toulouse Archive Ouverte (oatao) Relationship between Casting Modulus and Grain Size in Cast A356 Aluminium Alloys
Microstructure of Al-Si alloy castings depends most generally on melt preparation and on the cooling rate imposed by the thermal modulus of the component. In the case of Al-Si alloys, emphasis is put during melt preparation on refinement of pro-eutectic (Al) grains and on modification of the Al-Si eutectic. Thermal analysis has been used since long to check melt preparation before casting, i.e....
متن کاملFORMATION OF GLOBULAR STRUCTURES IN ALUMINUM A356 ALLOY BY NARROWMELT STREAM (NMS) TECHNIQUE
Abstract: structures in alloys. This method is based on pouring the melt through a small sized nozzle into a mould located at acertain height under the crucible. This simple method generates globular structures without using equipments such asimpellers, electromagnetic stirrers, ultrasonic probes and cooling slopes. Therefore it is cost effective. In the presentstudy, the effect of casting size...
متن کامل