Chirality-dependent friction of bulk molecular solids.

نویسندگان

  • Dian Yang
  • Adam E Cohen
چکیده

We show that the solid-solid friction between bulk chiral molecular solids can depend on the relative chirality of the two materials. In menthol and 1-phenyl-1-butanol, heterochiral friction is smaller than homochiral friction, while in ibuprofen, heterochiral friction is larger. Chiral asymmetries in the coefficient of sliding friction vary with temperature and can be as large as 30%. In the three compounds tested, the sign of the difference between heterochiral and homochiral friction correlated with the sign of the difference in melting point between racemate (compound or conglomerate) and pure enantiomer. Menthol and ibuprofen each form a stable racemic compound, while 1-phenyl-1-butanol forms a racemic conglomerate. Thus, a difference between heterochiral and homochiral friction does not require the formation of a stable interfacial racemic compound. Measurements of chirality-dependent friction provide a unique means to distinguish the role of short-range intermolecular forces from all other sources of dissipation in the friction of bulk molecular solids.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Concepts Of Boundary Friction Adhesion and Wear in Bulk Solids Handling Print

This paper is concerned with the evaluation of wall or boundary friction, adhesion and wear in bins and chutes of bulk solid handling plant. The relevant parameters influencing wall friction, such as surface roughness and particle size, are described and the manner in which friction, adhesion and cohesion influence performance of bins and chutes is discussed. Particular attention is focussed on...

متن کامل

Friction between solids.

The theoretical examination of the friction between solids is discussed with a focus on self-assembled monolayers, carbon-containing materials and antiwear additives. Important findings are illustrated by describing examples where simulations have complemented experimental work by providing a deeper understanding of the molecular origins of friction. Most of the work discussed herein makes use ...

متن کامل

Friction in colloids: bulk and edge effects

The field of friction especially at the mesoscopic and microscopic scales lacks fundamental understanding. One of the main difficulties is that we can observe only time-averaged values of the physical quantities because the atomistic dissipative nonlinear phenomena usually hide within an inaccessible interface between the sliding solids. The research carried out by Bohlein and colleagues shows ...

متن کامل

Chiral effect in plane isotropic micropolar elasticity and its application to chiral lattices

In continuummechanics, the non-centrosymmetric micropolar theory is usually used to capture the chirality inherent in materials. However, when reduced to a two dimensional (2D) isotropic problem, the resulting model becomes non-chiral. Therefore, influence of the chiral effect cannot be properly characterized by existing theories for 2D chiral solids. To circumvent this difficulty, based on rei...

متن کامل

An Experimental Correlation for Friction Factor in Horizontal Pipe with Trapezoidal Section Inner Longitudinal Slots for Conveying of Solids

In order to increase the efficiency of the conveyance of the granular solids, a new experimental set-up is designed. The test rig has longitudinal trapezoidal slots in its conveying pipes. Through experimentation, a correlation for friction factor in terms of solid mass flow rate, fluid flow rate and Froude number is presented. It is shown that the mixture friction factor for pipes with inn...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Langmuir : the ACS journal of surfaces and colloids

دوره 30 33  شماره 

صفحات  -

تاریخ انتشار 2014