Design and Performance of Ka-Band Fiber-Optic Delay Lines

نویسندگان

  • Vincent J. Urick
  • Joseph M. singley
  • Joseph M. Singley
  • Christopher E. Sunderman
  • John F. Diehl
  • Keith J. Williams
چکیده

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

All-Photonic Link for High-Performance Antenna Arraying

A stabilized all-photonic link is described that significantly simplifies X-band (approximately 8 to 12.5 GHz) and Ka-band (approximately 18 to 40 GHz) signal transport for high-performance antenna array applications. A cost-effective, integrated fiber-optic calibration technology provides long-term phase stability in the actual link used for broadband signal transport. This should directly ben...

متن کامل

Multiple-Beam Fiber-Optic Beamformer With Binary Array of Delay Lines

A multibeam optical beamformer capable of controlling a phased-array antenna in receive/transmit mode is proposed. The processor can be programmed to sweep the antenna aperture following an independent angular sequence for each radio-frequency (RF) beam. A two-beam two-channel 3-bit version of the beamformer has been experimentally demonstrated. The optical beamformer processes two independent ...

متن کامل

Fiber Optic Delay Line Systems

The 5017 delay lines system, incorporates a high-speed lasers and photodiodes to provide exceptionally high performance. The unit provides high bandwidth and sensitivity to operate with large delays, plus wide dynamic range for operation over a variety of loss budgets.

متن کامل

Evaluate The Behavior of PIN infrared detector via COMSOL software

Infrared detectors can be used for a variety of applications such as: using in fiber-optic communications. Conventional technology for IR detectors is using p-i-n structure based on GaAs compound. This paper reports on the design and modeling of an IR detector using a p-i-n GaAs structure. Comsol software is used to simulate the model and the detector is discussed for terminal current, dopant p...

متن کامل

Typical Ka band Satellite Beacon Receiver Design for Propagation Experimentation

This paper presents the design and simulation of a typical Ka band satellite beacon receiver for propagation experimentation. Using satellite beacon signal as a reference signal in satellite wave propagation study, is one of the most important methods. Satellite beacons are frequently available for pointing large antennas, but such signals can be used for measuring the effect of natural phenome...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2012