Growth of CuInS2 and its characterization
نویسندگان
چکیده
2014 Novel methods for the material synthesis, crystal growth and film preparation of CuInS2 were developed, some of their properties were characterized. CuInS2 single crystals were grown by iodine vapour transport. The habit-planes were determined to be (112) and (110). The lattice parameters were determined to be a = 5.517 Å, c = 11.122 Å (tetragonal). The as-grown crystals were n-type with resistivities in the order of 106 03A9-cm. Eight lattice vibration modes were characterized by Raman Scattering. Single phase CuInS2 thin films were prepaed by RF sputtering The as-deposited films were p-type with resistivities in the range of 10-1 to 101 03A9-cm. Back scattering was used for the film analysis. The feasibility of using flash evaporation to deposit single phase CuInS2 films has also been studied.
منابع مشابه
A Facile Solvothermal Method for Synthesis of CuInS2 Nanostructures
CuInS2 nanostructures were synthesized via a simple surfactant-free solvothermal route. In this synthesis, thiosemicarbazide and thioglycolic acid were used as sulfur sources. The effects of different parameters such as type of precursor and time on the morphology and particle size of the samples have been investigated. The nanostructures were characterized by means ...
متن کاملCharacterization of Spray Pyrolysed CuInS2 Thin Films
An indigenously developed chemical spray pyrolysis system was used to deposit polycrystalline CuInS2 thin films. It was found that smaller spray rate results in films with better crystallinity and lower resistivity. Increase in surface roughness of the films was observed for higher spray rates. Variations in film stoichiometry with composition of spray solution were analyzed along with its opto...
متن کاملCu1.94S-Assisted Growth of Wurtzite CuInS2 Nanoleaves by In Situ Copper Sulfidation
Wurtzite CuInS2 nanoleaves were synthesized by Cu1.94S-assisted growth. By observing the evolution of structures and phases during the growth process, Cu1.94S nanocrystals were found to be formed after uninterrupted oxidation and sulfidation of copper nanoparticles at the early stage, serving as catalysts to introduce the Cu and In species into CuInS2 nanoleaves growth for inherent property of ...
متن کاملOptimization of Annealing Process for Totally Printable High-current Superstrate CuInS2 Thin-Film Solar Cells
Planar superstrate CuInS2 (CIS) solar cell devices are fabricated using totally solution-processed deposition methods. A titanium dioxide blocking layer and an In2S3 buffer layer are deposited by the spray pyrolysis method. A CIS2 absorber layer is deposited by the spin coating method using CIS ink prepared by a 1-butylamine solvent-based solution at room temperature. To obtain optimum annealin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2016