Muscle activity and time to task failure differ with load compliance and target force for elbow flexor muscles.
نویسندگان
چکیده
The primary purpose of this study was to determine the influence of load compliance on time to failure during sustained isometric contractions performed with the elbow flexor muscles at four submaximal target forces. Subjects pulled against a rigid restraint during the force task and maintained a constant elbow angle, while supporting an equivalent inertial load during the position task. Each task was sustained for as long as possible. Twenty-one healthy adults (23 ± 6 yr; 11 men) participated in the study. The maximal voluntary contraction (MVC) force was similar (P = 0.95) before the subjects performed the force and position tasks at each of the four target forces: 20, 30, 45, and 60% of MVC force. The time to task failure was longer for the force tasks (576 ± 80 and 325 ± 70 s) than for the position tasks (299 ± 77 and 168 ± 35 s) at target forces of 20 and 30% (P < 0.001), but was similar for the force tasks (178 ± 35 and 86 ± 14 s) and the position tasks (132 ± 29 and 87 ± 14 s) at target forces of 45 and 60% (P > 0.19). The briefer times to failure for the position task at the lower forces were accompanied by greater rates of increase in elbow flexor muscle activity, mean arterial pressure, heart rate, and rating of perceived exertion. There was no difference in the estimates of external mechanical work at any target force. The dominant mechanisms limiting time to failure of sustained isometric contractions with the elbow flexor muscles appear to change at target forces between 30 and 45% MVC, with load compliance being a significant factor at lower forces only.
منابع مشابه
Time to failure of a sustained contraction is predicted by target torque and initial electromyographic bursts in elbow flexor muscles.
The purpose of the study was to identify factors that could predict differences among individuals in the time to failure of a submaximal contraction. Twenty subjects (10 men, 25+/-6 years) supported an inertial load equivalent to 20% of the maximal voluntary contraction (MVC) force with the elbow flexor muscles for as long as possible. The time to failure was predicted by the frequency of elect...
متن کاملActivation among the elbow flexor muscles differs when maintaining arm position during a fatiguing contraction.
Twenty-four men (n = 11) and women (n = 13) supported an inertial load equivalent to 20% of the maximum voluntary contraction force with the elbow flexor muscles for as long as possible while maintaining a constant elbow angle at 90 degrees. Endurance time did not differ on the three occasions that the task was performed (320 +/- 149 s; P > 0.05), and there was no difference between women (360 ...
متن کاملTask differences with the same load torque alter the endurance time of submaximal fatiguing contractions in humans.
Endurance time, muscle activation, and mean arterial pressure were measured during two types of submaximal fatiguing contractions that required each subject to exert the same net muscle torque in the two tasks. Sixteen men and women performed isometric contractions at 15% of the maximum voluntary contraction (MVC) force with the elbow flexor muscles, either by maintaining a constant force while...
متن کاملLoad type influences motor unit recruitment in biceps brachii during a sustained contraction.
Twenty subjects participated in four experiments designed to compare time to task failure and motor-unit recruitment threshold during contractions sustained at 15% of maximum as the elbow flexor muscles either supported an inertial load (position task) or exerted an equivalent constant torque against a rigid restraint (force task). Subcutaneous branched bipolar electrodes were used to record si...
متن کاملOlder adults use a unique strategy to lift inertial loads with the elbow flexor muscles.
The purpose of this study was to determine the effect of age on the ability to exert steady forces and to perform steady flexion movements with the muscles that cross the elbow joint. An isometric task required subjects to exert a steady force to match a target force that was displayed on a monitor. An anisometric task required subjects to raise and lower inertial loads so that the angular disp...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Journal of applied physiology
دوره 110 1 شماره
صفحات -
تاریخ انتشار 2011