Wear of a Total Knee Replacement with Antioxidant UHMWPE and Gradually Varying Sagittal Curvature
نویسندگان
چکیده
+MR Dressler, S Swope, J Tikka, C Hardaker, M Heldreth, T Render +DePuy Orthopaedics Research, Warsaw, IN [email protected] INTRODUCTION An estimated 46 million Americans suffer from osteoarthritis [1]. As tissue engineered treatments and other options remain on the horizon, total knee arthroplasty (TKA) continues to be an efficacious solution for severe osteoarthritis and has been increasingly applied to younger more active patients [2]. Consequently, new TKA devices are emerging that address previous challenges to long term success such as momentary instability, backside wear of modular devices, and oxidation of UHMWPE. The objective of this study was to evaluate the in vitro wear of a knee system with a novel femoral condyle geometry based upon a gradually changing sagittal curvature, refined tibio-femoral articulation, a new tibial insert locking mechanism, and an anti-oxidant containing poly material
منابع مشابه
Reduction of Total Knee Replacement Wear with Vitamin E doped highly cross linked UHMWPE
Introduction: Ultra high molecular weight polyethylene (UHMWPE) is a common bearing component in Total Knee Replacement (TKR) implants, and its susceptibility to wear continues to be the long-term limiting factor in the life of these implants. Novel material modifications have been introduced to reduce UHMWPE wear rates and thus improve the life of TKRs. Radiation and crosslinking of UHMWPE hav...
متن کاملInvestigation of Wear Behavior of Biopolymers for Total Knee Replacements Through Invitro Experimentation
The average life span of knee prosthesis used in Total Knee Replacement (TKR) is approximately 10 to 15 years. Literature indicates that the reasons for implant failures include wear, infection, instability, and stiffness. However, the majority of failures are due to wear and tear of the prosthesis. The most common biopolymer used in TKR is Ultra High Molecular Weight Polyethylene (UHMWPE). Pr...
متن کاملReduction of Wear in Fixed Bearing Total Knee Replacement Using Crosslinked Uhmwpe
Introduction Reduction of ultra high molecular weight polyethylene (UHMWPE) surface wear in total knee replacement (TKR) bearings may delay the onset of osteolysis and subsequent loosening of components. Crosslinking has been shown to increase the wear resistance of UHMWPE bearings in multidirectional total hip replacement applications when articulating against smooth counterfaces [1]. The aim ...
متن کاملEffects of Tibial Insert Slope on Polyethylene Wear and Stress
INTRODUCTION: Both posterior stabilized (PS) and cruciate retaining (CR) total knee replacement systems have demonstrated high rates of survivorship, high clinical knee scores and high patient satisfaction scores for decades. However, CR total knees sometimes exhibit more varied kinematics and a smaller range of motion than similar PS knees. Many factors can cause this, but one important factor...
متن کاملThe effect of insert conformity and material on total knee replacement wear
The mean average life is increasing; therefore, there is a need to increase the lifetime of the prostheses. To fulfil this requirement, new prosthetic designs and materials are being introduced. Two of the design parameters that may affect wear of total knee replacements, and hence the expected lifetime, are the insert conformity and material. Computational models have been used extensively for...
متن کامل