Using the T-scan III system to analyze occlusal function in mandibular reconstruction patients: a pilot study.
نویسندگان
چکیده
BACKGROUND This study was designed to analyze the post-rehabilitation occlusal function of subjects treated with complex mandibular resection and subsequently rehabilitated with fibula osteoseptocutaneous flaps, dental implants, and fixed prostheses utilizing the T-scan system. METHODS Ten mandibular complex resection cases that adopted fibula osteoseptocutaneous flaps, dental implants, and fixed prostheses to reconstruct occlusal function were analyzed. The mandibular reconstructions were divided into three groups based on size: full mandibular reconstructions, mandibular reconstructions larger than half of the arch, and mandibular reconstructions smaller than half of the arch. The T-scan III system was used to measure maximum occlusal force, occlusal time, anterior-posterior as well as left-right occlusal force asymmetries, and anterior-posterior as well as left-right asymmetrical locations of occlusal centers. RESULTS Subjects with larger mandibular reconstructions and dental implants with fixed partial dentures demonstrated decreased average occlusal force; however, the difference did not reach the statistically significant level (p > 0.05). The most significant asymmetry of occlusal center location occurred among subjects with mandibular reconstructed areas larger than half of the mandibular arch. CONCLUSIONS Comparison of the parameters of T-scan system used to analyze the occlusal function showed that the occlusal force was not an objective reference. Measurements of the location of the occlusal center appeared more repeatable, and were less affected by additional factors. The research results of this study showed that the size of a reconstruction did not affect the occlusal force after reconstruction and larger reconstructed areas did not decrease the average occlusal force. The most significant parameter was left and right asymmetry of the occlusion center (LROC) and was measured in subjects with reconstruction areas larger than half of the arch.
منابع مشابه
The relationship between unilateral mandibular angle fracture and temporomandibular joint function.
PURPOSE. Aim of this study was to analyze relation of occlusal correction and alterations of temporomandibular joint function during treatment of unilateral mandibular fractures. MATERIALS AND METHODS. We compared 49 patients treated for unilateral mandibular fracture without occlusal correction with 21 patient treated for unilateral mandibular fracture along with early and consequent occlusal ...
متن کاملAnalyzing dental occlusion for implants: Tekscan's TScan III.
Though no single, specific occlusal pattern has been developed that is ideal for oral implantology, research suggests some general criteria for deciding on a particular occlusal pattern that will help reduce cuspal interferences and lessen horizontal or lateral forces on the fixtures. Anticipated occlusal and chewing forces need to be taken under consideration for any implant-supported prosthes...
متن کاملAssociations between Impaction Depth of the Mandibular Third Molar and Pathological Conditions
Introdouction: Impacted and partially erupted third molars can cause various symptoms and pathologies. The aim of this study was to determine the association between commonly observed pathological conditions and the impaction depth of lower third molar teeth. Materials and methods: In this retrospective study, 370 panoramic radiographs including 724 lower third molars were evaluated to asses...
متن کاملReconstructionof Human Mandibular Continuity Defects with Allogenic Scaffold and Autologousmarrow Mesenchymal Stem Cells
Background Mandibular continuity defects occur after tumor resection, maxillofacial injury, or osteomyelitis. Despite the current availability of a plethora of treatment modalities, bone substitutes, and various clinical adjuncts, an exact reconstructive recapitulation of large bony defects continues to be beyond reach. In this clinical pilot study, we report a novel method for reconstruction ...
متن کاملComputerized occlusal analysis: correlation with occlusal indexes to assess the outcome of orthodontic treatment or the severity of malocculusion.
OBJECTIVE The aims of our study were to verify the validity of the T-Scan III system (Tekscan) as an objective occlusal evaluation tool, and to assess the differences between two occlusal indexes-the peer assessment rating (PAR) index and the American Board of Orthodontics objective grading system (OGS)-by comparing the scores derived from the T-Scan III system with the two occlusal indexes and...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Biomedical journal
دوره 38 1 شماره
صفحات -
تاریخ انتشار 2015