Effect of potential on temperature-dependent SERS spectra of neuromedin B on Cu electrode.
نویسندگان
چکیده
Adsorption of decapeptide neuromedin B (NMB) on copper electrode has been investigated by in situ surface-enhanced Raman scattering (SERS) spectroelectrochemistry in the temperature interval from 12 to 72 °C at -0.600 and -1.000 V potentials. It was found that intensities of peptide bands decrease at temperatures above 30 °C with higher decrease slope at -1.000 V. Frequency of F12 mode (1004 cm(-1)) of non-surface-interactive phenylalanine residue was found to be insensitive to temperature variation at both studied electrode potentials, while frequency-temperature curves for surface-interactive groups (Amide-III, methylene) were found to be controlled by the potential. In particular, opposite frequency-temperature trends were detected for Amide-III (Am-III) mode indicating decrease in H-bonding interaction strength of amide C[double bond, length as m-dash]O and N-H groups above 38 °C for -0.600 V, and increase in H-bonding interaction strength between 12 and 72 °C for -1.000 V. Anomalous Am-III temperature-dependence of the frequency at -1.000 V was explained by temperature-induced transformation of a disordered secondary structure to a helix-like conformation. The potential-difference spectrum revealed interaction of methylene groups with Cu surface at sufficiently negative potential values because of the appearance of a soft C-H stretching band near 2825 cm(-1) and a broad band near 2904 cm(-1) assigned to vibration of a distal C-H bond of the surface-confined methylene group. Consequently, a rapid decrease in frequency of CH(2)-stretching band with temperature was observed at -1.000 V, while no essential frequency changes were detected for this mode at -0.600 V. The results show that electrode potential controls the temperature-dependence of the frequency for vibrations associated with surface-interactive molecular groups.
منابع مشابه
Raman Investigations of Adsorbate-Substrate Interactions on Composite Ag (or Cu)/TiO2 Nanotubes/Ti Substrates
A tubular array of TiO2 nanotubes on Ti matrix was used as a support for Ag or Cu sputter-deposited layers intended for surface-enhanced Raman scattering (SERS) investigations. Composite samples of Ag/TiO2-nanotube/Ti and Cu/TiO2nanotube/Ti were studied with the aid of scanning electron microscopy (SEM) and Auger electron spectroscopy (AES and SAM) to reveal their characteristic morphological a...
متن کاملElectrochemical SERS study on a copper electrode of the insoluble organic pigment quinacridone quinone using ionic liquids (BMIMCl and TBAN) as dispersing agents.
SERS detection of quinacridone quinone (QAQ), an insoluble synthetic organic pigment relevant to modern artworks, is reported here. The use of ionic liquids (BMIMCl and TBAN) as dispersing agents has allowed us to carry out electrochemical SERS experiments of QAQ in aqueous solution using a Cu electrode. No SERS spectra were obtained either from the ionic liquids (ILs) or from QAQ when silver/g...
متن کاملWell-organized raspberry-like Ag@Cu bimetal nanoparticles for highly reliable and reproducible surface-enhanced Raman scattering.
Surface-enhanced Raman scattering (SERS) is ideally suited for probing and mapping surface species and incipient phases on fuel cell electrodes because of its high sensitivity and surface-selectivity, potentially offering insights into the mechanisms of chemical and energy transformation processes. In particular, bimetal nanostructures of coinage metals (Au, Ag, and Cu) have attracted much atte...
متن کاملSurface-Enhanced Raman Spectra of Pyridine and Pyrazine Adsorbed on a Au(210) Single-Crystal Electrode
Surface-enhanced Raman scattering (SERS) spectra of pyrazine and pyridine adsorbed on an “unroughened” Au(210) electrode surface have been obtained for the first time. The SERS spectra indicate that both pyridine and pyrazine adsorb on the Au(210) electrode via their nitrogen lone pairs (end-on configuration). The integrated SERS intensities from the ring-breathing vibrations (ca. 1010 cm-1 for...
متن کاملSurface Modification of Glassy Carbon Electrode by Ni-Cu Nanoparticles as a Competitive Electrode for Ethanol Electro-Oxidation
In the present study, Nickel-Copper nanoparticles were electrodeposited on glassy carbon electrode (GCE) by using electroplating deposition method. The prepared electrode was characterized by scanning electron microscopy (SEM) and elemental mapping analysis. Results showed that Ni-Cu nanoparticles with a high density are distributed at the surface of the glassy carbon electrode. Subsequentl...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Physical chemistry chemical physics : PCCP
دوره 15 3 شماره
صفحات -
تاریخ انتشار 2013