Measuring intrinsic elastic modulus of Pb/Sn solder alloys
نویسندگان
چکیده
Young’s modulus (E) values published in the literature for the eutectic Pb37/Sn63 and near eutectic Pb40/Sn60 solder alloy vary significantly. One reason for this discrepancy is different testing methods for highly rate sensitive heterogeneous materials, like Pb/Sn alloys, yield different results. In this paper, we study different procedures used to obtain the elastic modulus; analytically, by single crystal elasticity and experimentally by ultrasonic testing and nanoindentation. We compare these procedures and propose a procedure for elastic modulus determination. The deformation kinetics of the Pb/Sn solder alloys is discussed at the grain size level. 2002 Elsevier Science Ltd. All rights reserved.
منابع مشابه
Mechanical Characterization of Lead-Free Sn-Ag-Cu Solder Joints by High-Temperature Nanoindentation
The reliability of Pb-free solder joints is controlled by their microstructural constituents. Therefore, knowledge of the solder microconstituents' mechanical properties as a function of temperature is required. Sn-Ag-Cu lead-free solder alloy contains three phases: a Sn-rich phase, and the intermetallic compounds (IMCs) CueSn5 and Ag3Sn. Typically, the Sn-rich phase is surrounded by a eutectic...
متن کاملLow-Cycle Fatigue Characteristics of Sn-Based Solder Joints
Low-cycle, lap-shear fatigue behavior of Sn-based, Pb-free solder alloys, Sn3.5Ag, Sn-3.5Ag-Cu, Sn-3.5Ag-Bi, and Sn-0.7Cu, were studied at room temperature using specimens with printed circuit board (PCB)/solder/PCB structure under total displacement of ±10 μm, 12 μm, 15 μm, and 20 μm. The fatigue lives of various solder joint materials, defined as 50% load drop, were correlated with the fractu...
متن کاملThe Kinetics of Formation of Ternary Intermetallic Alloys in Pb-Sn and Cu-Ag-Sn Pb-free Electronic Joints
A simple model of the formation of Au0.1Ni0.1Sn0.8 in Pb-Sn solder/Ni interconnects is examined by numerical simulation. Previous experimental observation has shown that after reflow the interface consists of the Ni3Sn4 alloy between Pb-Sn solder and Ni, with Au distributed through the PbSn solder ball. Au0.1Ni0.1Sn0.8 was observed to form at the Pb-Sn solder/Ni3Sn4 interface during annealing a...
متن کاملLead-Free Soldering – Where The World Is Going
Lead-free soldering for electronic industry is a segment of global trend toward lead-free environment. Although initiated in U.S. in early 1990’s, it advanced much more rapidly in Japan and Europe. This differentiation in Pb-free progress triggered great concerns of users of Pb-containing solders about maintaining business opportunity, therefore further expedites the advancement of Pb-free sold...
متن کاملDevelopment of Sn-Based, Low Melting Temperature Pb-Free Solder Alloys
Low temperature, Sn-based Pb-free solders were developed by making alloy additions to the starting material, 96.5Sn-3.5Ag (mass%). The melting behavior was determined using Differential Scanning Calorimetry (DSC). The solder microstructure was evaluated by optical microscopy and electron probe microanalysis (EPMA). Shear strength measurements, hardness tests, intermetallic compound (IMC) layer ...
متن کامل