Frequency Tuning and Modulation of a Quantum Cascade Laser with an Integrated Resistive Heater
نویسندگان
چکیده
We present a detailed experimental investigation of the use of a novel actuator for frequency tuning and modulation in a quantum cascade laser (QCL) based on a resistive integrated heater (IH) placed close to the active region. This new actuator is attractive for molecular spectroscopy applications as it enables fast tuning of the QCL wavelength with a minor influence on the optical output power, and is electrically-controlled. Using a spectroscopic setup comprising a low-pressure gas cell, we measured the tuning and modulation properties of a QCL emitting at 7.8 μm as a function of the active region and IH currents. We show that a current step applied to the IH enables the laser frequency to be switched by 500 MHz in a few milliseconds, as fast as for a step of the current in the active region, and limited by heat dissipation towards the laser sub-mount. The QCL optical frequency can be modulated up to ~100 kHz with the IH current, which is one order of magnitude slower than for the QCL current, but sufficient for many spectroscopic applications. We discuss the experimental results using a thermal model of the heat transfer in terms of cascaded low-pass filters and extract the respective cut-off frequencies. Finally, we present a proof-of-principle experiment of wavelength modulation spectroscopy of a N2O transition performed with a modulation of the IH current and show some potential benefits in comparison to QCL current modulation, which results from the reduced associated amplitude modulation.
منابع مشابه
Analytical Investigation of Frequency Behavior in Tunnel Injection Quantum Dot VCSEL
The frequency behavior of the tunnel injection quantum dot vertical cavitysurface emitting laser (TIQD-VCSEL) is investigated by using an analyticalnumericalmethod on the modulation transfer function. The function is based on therate equations and is decomposed into components related to different energy levelsinside the quantum dot and injection well. In this way, the effect of the tunnelingpr...
متن کاملModulation Response and Relative Intensity Noise Spectra in Quantum Cascade Lasers
Static properties, relatively intensity noise and intensity modulation response in quantum cascade lasers (QCLs) studied theoretically in this paper. The present rate equations model consists of three equations for the electrons density in the conduction band and one equation for photons density in cavity length. Two equations were derived to calculate the noise and modulation response. Calcula...
متن کاملTemperature Effect on THz Quantum Cascade Lasers
A simple semi-phenomenological model, which accurately predicts the dependence of thresholdcurrent for temperature of Resonant-phonon three well quantum cascade laser based on verticaltransitions is offered. We found that, the longitude optical phonon scattering of thermally excitedelectrons is the most important limiting factor for thermal performance of high frequency THz QCLs.In low frequenc...
متن کاملNano-opto-mechanically modulated plasmonic nanoantenna-integrated quantum cascade laser
We report mechanical frequency and amplitude modulation of a quantum cascade laser (QCL) integrated with a plasmonic antenna operating at ~6.1 μm. We have observed a shift in the lasing frequency by over 30 GHz and an intensity modulation of ~74% when an atomic force microscope (AFM) tip approaches the hot spot of a metal-dielectricmetal (MDM) bow-tie antenna integrated onto the facet of the la...
متن کاملEnhanced Modulation and Noise Characteristics in 1.55 µm QD Lasers using Additional Optical Pumping
The modulation response, relative intensity noise (RIN) and frequency noise (FN) characteristics of quantum dot (QD) lasers are investigated theoretically in the presence of an external optical beam. Using small signal analysis of the rate equations for carriers and photons, it is demonstrated that by injecting excess carriers into the QDs excited state through optical pumping, the modulation r...
متن کامل