Bunch Compressor Ii at the Tesla Test Facility
نویسندگان
چکیده
In the TESLA Test Facility (TTF), short bunches with low emittance are needed for the operation of a free electron laser. Several stages of bunch compression by means of magnetic chicanes will be used to reach the required peak current. The second stage of the bunch compression system, bunch compressor II, has been taken into operation recently. We describe design and instrumentation of the bunch compressor II and communicate experiences made during commissioning.
منابع مشابه
Tolerances of Ttf-2 First Bunch Compressor
In bunch compressors for SASE-FEL facilities, the projected transverse emittance can be diluted by magnetic multipole component errors in dipoles and dipole misalignments as well as by coherent synchrotron radiation (CSR). In this paper, we describe the multipole field tolerances and the misalignment tolerances of the first bunch compressor (BC2) for the TESLA Test Facility Phase-2 (TTF-2).
متن کاملTesla-fel 2002-05
A design of a superconducting 3.9 GHz cavity for the injector of the TTF FEL-User Facility is presented. The cavity will be located after the first TESLA module with eight 1.3 GHz cavities and before the first bunch compressor. The purpose of the cavity is to cancel nonlinear distortions in the longitudinal phase space due to the cosine-like curvature of the 1.3 GHz accelerating cavity voltage....
متن کاملEmittance growth during bunch compression in the CTF-II
Measurements of the beam emittance during bunch compression in the CLIC Test Facility (CTF-II) are described. The measurements were made with different beam charges and different energy correlations versus the bunch compressor settings which were varied from no compression through the point of full compression and to overcompression. Significant increases in the beam emittance were observed wit...
متن کاملBeam Test of a Superconducting Cavity for the Fermilab High-brightness Electron Photo-injector
An electron photo-injector facility has been constructed at Fermilab for the purpose of providing a 14–18 MeV electron beam with high charge per bunch (8 nC), short bunch length (1 mm RMS), and small transverse emittance [1]. The facility was used to commission a second-generation photo-cathode RF gun for the TeSLA Test Facility (TTF) Linac at DESY [2, 3]; in the future, the Fermilab electron b...
متن کاملDesign and Construction of High Brightness RF Photoinjectors for TESLA
The design, construction and testing of a high brightness high bunch charge RF photoinjectormatching the requirements of the TESLA Test Facility is discussed. Engineering design work, the results of cold test measurements, and the planned experimental program are presented. Conceptual design work leading to an advanced high-brightness asymmetric emittance RF photoinjector for application to TES...
متن کامل