Main and Normal Cutting Forces by Machining Wood of Pinus Sylvestris
نویسندگان
چکیده
Although Pinus sylvestris L. is the most frequently analyzed wood species with respect to cutting forces in sawing experiments, the problem of prediction of reliable values of tangential FC and radial FN cutting forces for specific sawing conditions, according to the method employing a specific cutting resistance K (N·mm) and correction coefficients CR, C, C, CAP, CVC, CMC, CT, as expressed by Equations (1) and (2) is far from being solved (Afanasev 1961; Amalitskij and Lûbčenko 1977; Beršadskij 1967; Deševoj 1939; Orlicz 1982).
منابع مشابه
Cutting Forces by Oak and Douglas Fir Machining
In this work the multi-factor, non-linear dependencies between main (tangential) FC and normal (radial) FN cutting forces upon two machining parameters by up-routing and down-routing wood of Douglas fir (Pseudotsuga menziesii) and Oak (Quercus petraea) were evaluated. The relationships are graphically illustrated and discussed. The obtained data were compared with cutting forces evolution model...
متن کاملInvestigation of Cutting Forces Superalloy Inconel 718
Since the cutting tools used in machining process of super alloys are subjected to high cutting forces, accordingly tools life is reduced, therefore improvement in alloys machining and reducing cutting forces to achieve longer tools life is an essential necessity. In this research, the effect of changes in feed rate on cutting forces in machining process of nickel based super alloys is investig...
متن کاملSIMULATION AND MONITORING OF THE MACHINING PROCESS VIA FUZZY LOGIC AND CUTTING FORCES
On time replacement of a cutting tool with a new one is an important task in Flexible Manufacturing Systems (FMS). A fuzzy logic-based approach was used in the present study to predict and simulate the tool wear progress in turning operation. Cutting parameters and cutting forces were considered as the input and the wear rate was regarded as the output data in the fuzzy logic for construct...
متن کاملAnalysis of Milling Process Parameters and their Influence on Glass Fiber Reinforced Polymer Composites (RESEARCH NOTE)
Milling of fiber reinforced polymer composites is of great importance for integrated composites with other mating parts. Improper selection of cutting process parameters, excessive cutting forces and other machining conditions would result in rejection of components. Therefore, machining conditions are optimized to reduce the machining forces and damages. This work reports practical experiments...
متن کاملExperimental Study of the Cutting Parameters Effect on Hole Making Processes in Hardened Steel
Hardened steels are commonly used in wide areas of technologies and industries. In respect of poor machinability of these steels and requirement of expensive cutting tools, study of machining economy is a matter of importance. Thus the present study deals with the economic considerations of various hole making processes. For this purpose, the hard steel samples were machined by conventional dri...
متن کامل