On Hardness of the Joint Crossing Number
نویسندگان
چکیده
The Joint Crossing Number problem asks for a simultaneous embedding of two disjoint graphs into one surface such that the number of edge crossings (between the two graphs) is minimized. It was introduced by Negami in 2001 in connection with diagonal flips in triangulations of surfaces, and subsequently investigated in a general form for smallgenus surfaces. We prove that all of the commonly considered variants of this problem are NP-hard already in the orientable surface of genus 6, by a reduction from a special variant of the anchored crossing number problem of Cabello and Mohar.
منابع مشابه
Effectiveness of Joint Stiffness and Power Alternations in Different Shoe Insole Hardness on Injury Prevention During Jump-Landing
Background: Studies on how the shoe insole hardness regulate joint stiffness and transfer energy in the lower extremity during jump landing are scarce. The current study aimed to determine the effectiveness of shoe insole changes in joint power and stiffness during landing from jumps. Methods: Fifteen healthy male athletes volunteered to perform jump-landing in various shoe insole conditions. ...
متن کاملHardness of approximation for crossing number
We show that, if P6=NP, there is a constant c0 > 1 such that there is no c0approximation algorithm for the crossing number, even when restricted to 3-regular graphs.
متن کاملThe Effect of the AA7075 Interlayer on the Microstructure and Mechanical Properties of the AA1050 Butt Joint Welded by FSW
In this research, the FSW Butt joint of commercial aluminum 1050 was investigated by using the 7075 aluminum alloy interlayer on the linear velocity of 30, 50 and 100 mm / min, and rotational speeds of 800 and 1200 rpm. A threaded cylindrical tool was used for joining of the 5 mm sheets. The OM, SEM, microhardness and tensile tests were done. The results shows that in sample with an interlayer ...
متن کاملFriction stir welding of dissimilar joint of aluminum alloy 5083 and commercially pure titanium
In this study, commercially pure titanium and aluminum alloy 5083 in connection rotational speed of 1120 rpm and a feed rate of 50 mm per minute for butt welding by friction stir welding has been successfully completed. Micro-structure, hardness and tensile test was conducted on the connection. Welding area is a composite of aluminum and titanium particles that the particles plays an important ...
متن کاملThe Effect of the AA7075 Interlayer on the Microstructure and Mechanical Properties of the AA1050 Butt Joint Welded by FSW
In this research, the FSW Butt joint of commercial aluminum 1050 was investigated by using the 7075 aluminum alloy interlayer on the linear velocity of 30, 50 and 100 mm / min, and rotational speeds of 800 and 1200 rpm. A threaded cylindrical tool was used for joining of the 5 mm sheets. The OM, SEM, microhardness and tensile tests were done. The results shows that in sample with an interlayer ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2015