Structure of ordered and disordered InxGa1 xP(001) surfaces prepared by metalorganic vapor phase epitaxy

نویسندگان

  • S. F. Cheng
  • Y. Sun
  • D. C. Law
  • S. B. Visbeck
  • R. F. Hicks
چکیده

Ordered and disordered InGaP(001) films were grown by metalorganic vapor-phase epitaxy and studied by low energy electron diffraction, reflectance difference spectroscopy, and X-ray photoemission spectroscopy. Both alloy surfaces were covered with a monolayer of buckled phosphorus dimers, where half of the phosphorus atoms were terminated with hydrogen. Ordered InGaP(001) appeared indium rich, and exhibited a reflectance difference spectrum like that of InP(001). These results support a model whereby the strain energy on the ordered InGaP surface is reduced by aligning the group III atoms in alternating [110] rows, with the indium and gallium bonding to the buckled-down and buckled-up phosphorus atoms, respectively. 2006 Elsevier B.V. All rights reserved.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Surface phases of GaAs and InAs „001... found in the metalorganic vapor-phase epitaxy environment

We have characterized the ~234! and ~432! reconstructions of GaAs and InAs ~001! that are present in a metalorganic vapor-phase epitaxy ~MOVPE! reactor. Scanning tunneling micrographs show that these surfaces are terminated with arsenic and gallium ~or indium! dimers. The ~234! dimer row exhibits a mottled appearance, which is ascribed to the adsorption of alkyl groups on some of the sites. On ...

متن کامل

Structure of arsenic-treated indium phosphide „001... surfaces during metalorganic vapor-phase epitaxy

We have studied the initial stages of heterojunction formation during the metalorganic vapor-phase epitaxy of indium arsenide on indium phosphide. Exposing an InP ~001! film to 10 mTorr of tertiarybutylarsine below 500 °C results in the deposition of a thin InAs layer from 1.5 to 5.0 atomic layers thick ~2.3–7.5 Å!. The surface of this epilayer remains atomically smooth independent of arsenic e...

متن کامل

Reflectance difference spectroscopy of gallium phosphide„001... surfaces

Gallium phosphide~001! surfaces have been prepared by metalorganic vapor-phase epitaxy, and characterized in situ by low-energy electron diffraction, x-ray photoemission spectroscopy, and reflectance difference spectroscopy. Three stable phases were observed: (231), (131), and (2 34) with phosphorus coverages of 1.00, 0.67, and 0.13 ML, respectively. Reflectance difference spectra obtained at c...

متن کامل

Preparation of epitaxial PbTiO 3 thin films by metalorganic vapor phase epitaxy under reduced pressure

In this study PbTiO 3 thin films were deposited using metalorganic vapor phase epitaxy (MOVPE). Titanium-isopropoxide and tetraethyl-lead were used as the Ti and Pb precursors, and 0 2 was the oxidizing gas. A wide range of conditions for preparing high quality PbTiO 3 thin film were investigated. The epitaxial PbTiO 3 thin films were grown on (001) SrTiO 3 substrates at a growth temperature of...

متن کامل

Defect ordering in epitaxial a-GaN(QQ01)

The microstructure of nominally undoped epitaxial wurtzite-structure o-GaN films, grown by gas-source molecular-beam epitaxy, plasma-assisted molecular-beam epitaxy, and metalorganic chemical-vapor deposition, has been investigated by transmission electron microscopy (TEM) and high-resolution TEM. The results show that undoped a-GaN films have an ordered point-defect structure. A model of this ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2006