Calibration of the Beam-position Monitor System for the Slac Pep-i1 B Factory
نویسنده
چکیده
The Beam-Position Monitors (BPM) for the PEP-11 B Factory consist of four 1.5cm diameter button style pickups mounted on the diagonals of the quadrupole vacuum chambers. Before installation of the vacuum chambers in the quadrupole assemblies, the electrical center of the BPMs is measured with respect to the mechanical center in a calibration test stand. In this paper the calibrations test stand is described and the precision and accuracy of the calibrations are presented. After installation of the quadrupole assemblies in the PEP-11 tunnel, the passive attenuation for each channel of the system is measured to preserve the accuracy of the calibration. Finally, the active electronics includes an on-board calibrator. Results for these portions of the calibration are presented. Submitted to the 1997 Particle Accelerator Conference, 12-16 May 1997, Vancouver, B.C., Canada * Work supported by Department of Energy contract DE-ACO3-76SFOO5 15 (SLAC), W-7405-Eng-48 (LLNL), and DE-ACO3-76SFOOO98 (LBNL).
منابع مشابه
Calibration of the Beam-Position Monitor System for the SLAC PEP-II B Factory
The Beam-Position Monitors (BPM) for the PEP-II B Factory consist of four 1.5cm diameter button style pickups mounted on the diagonals of the quadrupole vacuum chambers. Before installation of the vacuum chambers in the quadrupole assemblies, the electrical center of the BPMs is measured with respect to the mechanical center in a calibration test stand. In this paper the calibrations test stand...
متن کاملPerformance of the Beam Position Monitor System for the SLAC PEP-II B Factory
the beam position monitor (BPM) system for the SLAC PEP-II B Factory was designed to measure the positions of single-bunch single-turn to multibunch multi-turn beams in both rings of the facility. Each BPM is based on four button-style pickups. At most locations the buttons are connected to provide single-axis information (x only or y only). Operating at a harmonic (952 MHz) of the bunch spacin...
متن کاملRf Modes in the Pep-ii Shielded Vertex Bellows*
Experimental and simulation study of RF modes were carried out for the complicated geometry of the shielded vertex bellows near the IP region of the PEP-II B-factory. A beam position monitor button electrode located 50 cm from the bellows provides a signal for spectrum measurement. Calculations indicate monopole, dipole and quadrupole modes can exist in the bellows structure near the experiment...
متن کاملAnalysis of the Wake Field Effects in the Pep-ii Slac B- Factory*
We present the history and analysis of different wake field effects throughout the operational life of the PEP-II SLAC B-factory. Although the impedance of the high and low energy rings is small, the intense high current beams generated a lot of power. The effects from these wake fields are: heating and damage of vacuum beam chamber elements like RF seals, vacuum valves , shielded bellows, BPM ...
متن کاملStatus of the Pep–ii B-factory High Energy Ring*
The 9 GeV High Energy Ring (HER) of the PEP-II B Factory is an electron storage ring under construction at SLAC. Significant progress has been made in the last year on all systems. As of mid 1996, all 192 dipoles have been installed, with installation of the quadrupoles underway. The vacuum system, for design currents up to 3 A average, is in production using a recently commissioned e-beam weld...
متن کامل