On vortex shedding from an airfoil in low-Reynolds-number flows
نویسندگان
چکیده
Development of coherent structures in the separated shear layer and wake of an airfoil in low-Reynolds-number flows was studied experimentally for a range of airfoil chord Reynolds numbers, 55×10 Rec 210×10, and three angles of attack, α=0◦, 5◦ and 10◦. To illustrate the effect of separated shear layer development on the characteristics of coherent structures, experiments were conducted for two flow regimes common to airfoil operation at low Reynolds numbers: (i) boundary layer separation without reattachment and (ii) separation bubble formation. The results demonstrate that rollup vortices form in the separated shear layer due to the amplification of natural disturbances, and these structures play a key role in flow transition to turbulence. The final stage of transition in the separated shear layer, associated with the growth of a sub-harmonic component of fundamental disturbances, is linked to the merging of the roll-up vortices. Turbulent wake vortex shedding is shown to occur for both flow regimes investigated. Each of the two flow regimes produces distinctly different characteristics of the roll-up and wake vortices. The study focuses on frequency scaling of the investigated coherent structures and the effect of flow regime on the frequency scaling. Analysis of the results and available data from previous experiments shows that the fundamental frequency of the shear layer vortices exhibits a power law dependency on the Reynolds number for both flow regimes. In contrast, the wake vortex shedding frequency is shown to vary linearly with the Reynolds number. An alternative frequency scaling is proposed, which results in a good collapse of experimental data across the investigated range of Reynolds numbers.
منابع مشابه
Control of vortex shedding on two- and three-dimensional airfoils
We review and expand on the control of separated flows over flat plates and airfoils at low Reynolds numbers associated with micro air vehicles. Experimental observations of the steady-state and transient lift response to actuation, and its dependence on the actuator, airfoil geometry, and flow conditions are discussed and an attempt is made to unify them in terms of their excitation of periodi...
متن کاملDrag coefficient and strouhal number analysis of a rectangular probe in a two-phase cross flow
In some case of laboratory and industrial applications, various kind of measurement instruments must be placed in a conduit, in which multiphase fluid flows. Vortex shedding for any immersed body in flow field is created with a frequency, which according to flow conditions such as flow rates, geometry of body, etc. may be constant or variable. Failure may happen, if this frequency is close to o...
متن کاملThermal Field Around a Circular Cylinder with Periodic Vortex Shedding
A numerical study is carried out to investigate the laminar forced convection heat transfer from a circular cylinder. The fluid is assumed to be incompressible, the Reynolds number ranged from 0.1 to 1000, and the Prandtl number was equal to 0.7. The range of study includes heat transfer in creeping flow (Re40). The equations were discretized by a control-volume-based finite difference techniqu...
متن کاملEffects of Unequal Pitch and Plunge Airfoil Motion Frequency on Aerodynamic Response
Departing from mainstream pitching/plunging airfoil literature, we consider scenarios where the frequencies of the plunge and the pitch are not equal. The motivation is, first, consideration of flows with very large excursions in total angle of attack, for assessment of motion time history effects; and second, an attempt to model the gust response of flapping-wing Micro Air Vehicles by consider...
متن کاملDrag coefficient and strouhal number analysis of cylindrical tube in two phase flow
In many industrial equipment such as boilers and heat exchangers, the cylindrical tubes are exposed to the gas- liquid two phase flow. For any immersed body in flow field vortex shedding is created with a frequency that may be constant or variable, according to conditions such as flow rates, geometry of body, and etc. The failure will happen in the equipment, when this frequency is close to...
متن کامل