Note: a transimpedance amplifier for remotely located quartz tuning forks.
نویسندگان
چکیده
The cable capacitance in cryogenic and high vacuum applications of quartz tuning forks imposes severe constraints on the bandwidth and noise performance of the measurement. We present a single stage low noise transimpedance amplifier with a bandwidth exceeding 1 MHz and provide an in-depth analysis of the dependence of the amplifier parameters on the cable capacitance.
منابع مشابه
A High Sensitivity Preamplifier for Quartz Tuning Forks in QEPAS (Quartz Enhanced PhotoAcoustic Spectroscopy) Applications
All the preamplifiers dedicated for Quartz Enhanced PhotoAcoustic Spectroscopy (QEPAS) applications that have so far been reported in the literature have been based on operational amplifiers working in transimpedance configurations. Taking into consideration that QEPAS sensors are based on quartz tuning forks, and that quartz has a relatively high voltage constant and relatively low charge cons...
متن کاملA current to voltage converter for cryogenics using a CMOS operational amplifier
We have constructed a versatile current to voltage (I-V ) converter operating at liquid helium temperature, using a commercially available all-CMOS OPamp. It is valuable for cryogenic measurements of electrical current of nano-pico amperes, for example, in scanning probe microscopy. The I-V converter is thermally linked to liquid helium bath and self-heated up to 10.7 K. We have confirmed its c...
متن کاملPiezoelectric Quartz Tuning Forks for Scanning Probe Microscopy
In this paper the application of piezoelectric quartz tuning forks in dynamic force microscopy is described. For the introduction we give a historical overview and a comparison with traditional cantilevers. In the second section the theories for tuning forks as oscillators for the dynamic force detection are introduced and in the third section the experimental implementation is described. This ...
متن کاملAnalyzing the Effect Adding an Active Feedback Network with an Inductive behavior to a Common-Gate Topology as a Transimpedance Amplifier for Low-Power and Wide-Band Communication Applications
Common Gate (CG) topologies are commonly used as the first stage in Transimpedance Amplifiers (TIA), due to their low input resistance. But, this structure is not solely used as a TIA and comes with other topologies such as differential amplifiers or negative resistances and capacitances. This paper deals with analyzing the effect of adding an active feedback network to a common gate topology...
متن کاملVisualized Multiprobe Electrical Impedance Measurements with STM Tips Using Shear Force Feedback Control
Here we devise a multiprobe electrical measurement system based on quartz tuning forks (QTFs) and metallic tips capable of having full 3D control over the position of the probes. The system is based on the use of bent tungsten tips that are placed in mechanical contact (glue-free solution) with a QTF sensor. Shear forces acting in the probe are measured to control the tip-sample distance in the...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- The Review of scientific instruments
دوره 83 12 شماره
صفحات -
تاریخ انتشار 2012