Ultra-Wideband Printed Antennas Design

نویسنده

  • Mohamed Nabil Srifi
چکیده

On February 14, 2002, the Federal Communications Commission (FCC) of the United States adopted the First Report and Order that permitted the commercial operation of ultra wideband (UWB) technology (FCC, 2002). The FCC allocated a bandwidth of 7.5GHz, i.e. from 3.1GHz to 10.6GHz, to unlicensed use for UWB applications. Ultra Wideband is defined as any communication technology that occupies greater than 500 MHz of bandwidth, or greater than 25% of the operating center frequency. The UWB spectral mask was defined to allow a spectral density of -41.3 dBm / MHz throughout the UWB frequency band. UWB technology has several advantages that are the reasons that make it very attractive for consumer communications applications; it has been regarded as one of the most promising wireless technologies that have a capability of revolutionizing high data rate transmission and enables the personal area networking industry leading to new innovations and greater quality of services to the end users. Ultra wideband systems present several advantages i) have potentially low complexity and low cost; ii) have noise-like signal which makes unintended detection quite difficult, because of their low average transmission power, UWB communications systems have an inherent immunity to detection and interception; and low power consumption; iii) are resistant to severe multipath and jamming; and iiii) have very good time domain resolution allowing for location and tracking applications. Also UWB systems can penetrate effectively through different materials. The low frequencies included in the broad range of the UWB frequency band have long wavelengths, which allow UWB signals to penetrate into a variety of materials, such as walls. This advantage makes UWB technology favourable for through the wall communications, ground penetrating radar, body implant wireless communications... Since UWB has an ultra wide frequency bandwidth, it can achieve huge capacity as high as hundreds of Mbps or even several Gbps with distances of 1 to 10 meters (Oppermann, 2004). UWB systems operate at extremely low power transmission levels, and hence UWB signals do not cause significant interference to other wireless systems. The UWB technology is one of the viable candidates for short-range indoor radio communication systems supporting very high bit rates services and applications. In this chapter, different aspects and challenges of UWB antennas design are discussed. And compact printed disc monopole antenna (3.5 to 31.9 GHz) for current and future ultra wideband applications will be presented.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Design and Miniaturization of a Novel Fractal Microstrip Antenna for UWB Applications

A novel printed octagonal fractal microstrip antenna with semi-elliptical ground plane is presented for ultra wide band applications. The proposed antenna has a compact size of 20×20×1 mm³. The measured result of the antenna exhibits the ultra wide band characteristics from 2/9 to 14/2 GHz. In this paper, reducing antenna’s size by 35%, the same results were achieved, while small dimension frac...

متن کامل

Ultra Wideband Antennas – Past and Present

Since the release by the Federal Communications Commission (FCC) of a bandwidth of 7.5GHz (from 3.1GHz to 10.6GHz) for ultra wideband (UWB) wireless communications, UWB is rapidly advancing as a high data rate wireless communication technology. As is the case in conventional wireless communication systems, an antenna also plays a very crucial role in UWB systems. However, there are more challen...

متن کامل

Modified U-Slot Stacked Micro-Strip Patch Antenna for Ultra-Wideband Applications in S Band, C Band and X Band

The U-slot micro-strip patch antennas were originally developed for bandwidth broadening applications. This study presents a transmission line feed to modify the U-slot stacked rectangular micro-strip patch antenna for Ultra-Wide Band (UWB) communications. The modified antenna has a U-cut loaded with parallel slits and corner slots and is printed on a dielectric substrate of FR4 with relative p...

متن کامل

Design Aspects of PrintedMonopole Antennas for Ultra-Wide Band Applications

This paper presents the design equations for lower band-edge frequency for all the regular shapes of printed monopole antennas with various feed positions. The length of the feed transmission line is a critical design parameter of these monopole antennas. Design curves for the length of the feed transmission line for various lower band-edge frequencies for all these regular shaped monopoles hav...

متن کامل

Printed UWB Circular and Modified Circular Disc Monopole Antennas

In this paper, we have investigated printed monopole antennas, which is basically printed microstrip antenna with etched ground plane for UWB applications. In particular, we have simulated two types of UWB printed monopole antennas: circular and modified circular disk monopole antennas. Simple rectangular microstrip lines are used for feeding the printed monopole antennas. This UWB monopole ant...

متن کامل

Characterisation of Printed UWB Antennas for On- Body Communications

Low-profile, compact and easily integrated body worn antennas are the essence of efficient, reliable and user-friendly body-centric networks. The paper presents different planar printed ultra wideband (UWB) antennas and their applications as part of on-body communication systems. Both frequency and time domain characteristics of the proposed antennas are investigated and analysed. The paper emp...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2012