FGM ROTATING DISC FABRICATE BY Al/Al2O3
نویسنده
چکیده
Our aim of is to develop a processing method for a rotating disc made of functionally graded materials (FGM), by stacking the slurry, layer by layer in a radial direction. A three-layer functionally graded material of Al/Al2O3 is fabricated with compositions of 10, 20, 30 vol.% Al2O3. The ceramic composition increases from the discs inner (centre) to the outer. The combination of these materials can offer the ability to withstand high temperature conditions whilst maintaining strength in extreme environments. In this paper we present a method of fabricating a disc made of Al/Al2O3 functionally graded materials (FGM), using a powder metallurgy manufacturing process.
منابع مشابه
Creep Analysis of an Isotropic Functionally Graded Rotating Disc
Abstract Creep response for isotropic axisymmetric rotating disc made of a particle-reinforced FGM has been investigated in the present study. The result obtained for non linear variation of particle distribution along the radial distance of the disc are compared with that of discs containing the same amount of particle distributed uniformly or linearly along the radial distance. The disc under...
متن کاملPRODUCTION OF TiAl/Al2O3 AND TiAl/Ti2AlC/Al2O3 COMPOSITES BY EXPLOSION SYNTHESIS
Thermal explosion mode of combustion synthesis was used to fabricate TiAl-Al2O3 and TiAl-Ti2AlC-Al2O3 composites from elemental powder mixtures of TiO2, Al and C and characterized by XRD and Scanning Electron Microscopy (SEM) coupled with Energy-Dispersive Spectroscopy (EDS). The experimental results showed that thermite reaction of Al with TiO2 caused TiAl-Al2O3 composite formation. By adding ...
متن کاملMechanical Stresses in a Linear Plastic FGM Hollow and Solid Rotational Disk
In this paper, an analytical solution for computing the plastic & linear plastic stresses and critical angular velocity in a FGM hollow & solid rotating disk is developed. It has been assumed that the modulus of elasticity and yield strength were varying through thickness of the FGM material according to a power law relationship. The Poisson's ratio were considered constant throughout the thick...
متن کاملAn Investigation of Stress and Deformation States of Rotating Thick Truncated Conical Shells of Functionally Graded Material
The present study aims at investigating stress and deformation behavior of rotating thick truncated conical shells subjected to variable internal pressure. Material prpperties of the shells are graded along the axial direction by Mori-tanaka scheme, which is achieved by elemental gradation of the properties.Governing equations are derived using principle of stsionary total potential (PSTP) and ...
متن کاملMechanical properties of Si3N4–Al2O3 FGM joints with 15 layers for high-temperature applications
Mechanical properties of Si3N4–Al2O3 FGM joints with 15 layers for high-temperature applications C.S. Lee a,∗, J.A. Lemberg b,c, D.G. Cho a, J.Y. Roh a, R.O. Ritchie b,c a Division of Material and Chemical Engineering, Hanyang University, Gyeonggi-do, Republic of Korea b Materials Sciences Division, Lawrence Berkeley National Laboratory, Berkeley, CA 94720, USA c Department of Materials Science...
متن کامل