Generation of chaotic radiation in a driven traveling wave tube amplifier with time-delayed feedback

نویسندگان

  • Chad Marchewka
  • Paul Larsen
  • Sudeep Bhattacharjee
چکیده

The application of chaos in communications and radar offers new and interesting possibilities. This article describes investigations on the generation of chaos in a traveling wave tube !TWT" amplifier and the experimental parameters responsible for sustaining stable chaos. Chaos is generated in a TWT amplifier when it is made to operate in a highly nonlinear regime by recirculating a fraction of the TWT output power back to the input in a delayed feedback configuration. A driver wave provides a constant external force to the system making it behave like a forced nonlinear oscillator. The effects of the feedback bandwidth, intensity, and phase are described. The study illuminates the different transitions to chaos and the effect of parameters such as the frequency and intensity of the driver wave. The detuning frequency, i.e., difference frequency between the driver wave and the natural oscillation of the system, has been identified as being an important physical parameter for controlling evolution to chaos. Among the observed routes to chaos, besides the more common period doubling, a new route called loss of frequency locking occurs when the driving frequency is adjacent to a natural oscillation mode. The feedback bandwidth controls the nonlinear dynamics of the system, particularly the number of natural oscillation modes. A computational model has been developed to simulate the experiments and reasonably good agreement is obtained between them. Experiments are described that demonstrate the feasibility of chaotic communications using two TWTs, where one is operated as a driven chaotic oscillator and the other as a time-delayed, open-loop amplifier. © 2006 American Institute of Physics. #DOI: 10.1063/1.2161170$

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Second Harmonic Reduction of Traveling Wave Tube Amplifier Using Ferrite Material

Traveling Wave Tubes (TWTs) consist of different elements. The most important element of TWT is the RF circuit. RF circuits in helix TWTs need a dielectric support to hold the helix; this support also has an effect in electromagnetic properties of RF circuits. A novel dielectric support is proposed to reduce the second harmonic of helix TWTs. The dielectric support in this structure consists of...

متن کامل

Stabilization of chaotic systems via fuzzy time-delayed controller approac

In this paper, we investigate the stabilization of unstable periodic orbits of continuous time chaotic systems usingfuzzy time-delayed controllers. For this aim, we present a control method that can achieve stabilization of an unstableperiodic orbit (UPO) without any knowledge of the system model. Our proposal is attained progressively. First, wecombine the input-to-state linearizing controller...

متن کامل

Sideband development in a high-power traveling-wave tube microwave amplifier

The work presented describes the characteristics of single stage and severed high-efficiency, high-power traveling-wave tube amplifiers operating in X band at 8.76 GHz. Average amplified output powers of 210 MW have been achieved at 24% efficiency. At high output power levels ( > 100 MW) sidebands develop increasing the average radiated power to over 400 MW with a microwave conversion efficienc...

متن کامل

High-Power Microwave Generation Using A Ferroelectric Cathode Electron Gun

A two-stage 500 kV 200-A ferroelectric electron gun has been designed, fabricated, tested, and used in a high power microwave amplifier experiment. We report on the operational characteristics of the gun including measurements of the beam dynamics. The optimum conditions for application of the trigger and its timing are also reported. Faraday cup measurement shows that the beam radius is 4.1 mm...

متن کامل

Non-linear modeling, analysis, design and simulation of a solid state power amplifier based on GaN technology for Ku band microwave application

A new non-linear method for design and analysis of solid state power amplifiers is presented and applied to an aluminum gallium nitride, gallium nitride (AlGaN-GaN) high electron-mobility transistor (HEMTs) on silicon-carbide (SiC) substrate for Ku band (12.4 13.6 GHz) applications. With combining output power of 8 transistors, maximum output power of 46.3 dBm (42.6 W), PAE of 43% and linear ga...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2007