Mixed Convection Boundary Layer Flow on a Vertical Surface in a Porous Medium Saturated by a Nanofluid with Suction or Injection
نویسندگان
چکیده
An analysis of the steady mixed convection boundary layer flow past a vertical permeable surface embedded in a porous medium saturated by a nanofluid is performed in this study. Numerical solutions of the similarity equations are obtained using the shooting method. Three types of metallic or nonmetallic nanoparticles, namely Copper (Cu), Alumina (Al2O3) and Titania (TiO2) are considered by using a water-based fluid to investigate the effect of the solid volume fraction or nanoparticle volume fraction parameter φ of the nanofluid. The numerical results of the skin friction coefficient and the velocity profiles are presented and discussed. It is found that the imposition of suction is to increase the velocity profiles and to delay the separation of boundary layer, while the injection parameter decreases the velocity profiles. On the other hand, the range of solutions for the injection case is largest for Al2O3 nanoparticles and smallest for Cu nanoparticles.
منابع مشابه
Effect of heat source/sink on MHD Mixed convection Boundary layer flow on a vertical surface in a porous medium saturated by a nanofluid with suction or injection
The effect of heat source/sink on steady two-dimensional laminar MHD mixed convection boundary layer flow past a vertical permeable surface embedded in a porous medium saturated by a nanofluid is performed in this study. Numerical solutions of the similarity equations are obtained using the shooting method. Three types of metallic or nonmetallic nanoparticles, namely Copper (Cu), Alumina (Al2O3...
متن کاملConjugate Heat Transfer of MHD non-Darcy Mixed Convection Flow of a Nanofluid over a Vertical Slender Hollow Cylinder Embedded in Porous Media
In this paper, conjugate heat transfer of magneto hydrodynamic mixed convection of nanofluid about a vertical slender hollow cylinder embedded in a porous medium with high porosity have been numerically studied. The Forchheimer’s modification of Darcy’s law was used in representing the nanofluid motion inside the porous media. The governing boundary layer equations were transformed to non-dimen...
متن کاملEffects of Brownian motion and Thermophoresis on MHD Mixed Convection Stagnation-point Flow of a Nanofluid Toward a Stretching Vertical Sheet in Porous Medium
This article deals with the study of the two-dimensional mixed convection magnetohydrodynamic (MHD) boundary layer of stagnation-point flow over a stretching vertical plate in porous medium filled with a nanofluid. The model used for the nanofluid incorporates the effects of Brownian motion and thermophoresis in the presence of thermal radiation. The skin-friction coefficient, Nusselt number an...
متن کاملMixed Convection Boundary Layer Flow over a Permeable Vertical Flat Plate Embedded in an Anisotropic Porous Medium
An analysis is performed to study the heat transfer characteristics of steady mixed convection flow over a permeable vertical flat plate embedded in an anisotropic fluid-saturated porous medium. The effects of uniform suction and injection on the flow field and heat transfer characteristics are numerically studied by employing an implicit finite difference Keller-box method. It is found that du...
متن کاملUnsteady Heat and Mass Transfer Near the Stagnation-point on a Vertical Permeable Surface: a Comprehensive Report of Dual Solutions
In this paper, the problem of unsteady mixed convection boundary layer flow of a viscous incompressible fluid near the stagnation-point on a vertical permeable plate with both cases of prescribed wall temperature and prescribed wall heat flux is investigated numerically. Here, both assisting and opposing buoyancy forces are considered and studied. The non-linear coupled partial differential equ...
متن کامل