A study on the evaluations of emission factors and uncertainty ranges for methane and nitrous oxide from combined-cycle power plant in Korea
نویسندگان
چکیده
In this research, in order to develop technology/country-specific emission factors of methane (CH(4)) and nitrous oxide (N(2)O), a total of 585 samples from eight gas-fired turbine combined cycle (GTCC) power plants were measured and analyzed. The research found that the emission factor for CH(4) stood at "0.82 kg/TJ", which was an 18 % lower than the emission factor for liquefied natural gas (LNG) GTCC "1 kg/TJ" presented by Intergovernmental Panel on Climate Change (IPCC). The result was 8 % up when compared with the emission factor of Japan which stands at "0.75 kg/TJ". The emission factor for N(2)O was "0.65 kg/TJ", which is significantly lower than "3 kg/TJ" of the emission factor for LNG GTCC presented by IPCC, but over six times higher than the default N(2)O emission factor of LNG. The evaluation of uncertainty was conducted based on the estimated non-CO(2) emission factors, and the ranges of uncertainty for CH(4) and N(2)O were between -12.96 and +13.89 %, and -11.43 and +12.86 %, respectively, which is significantly lower than uncertainties presented by IPCC. These differences proved that non-CO(2) emissions can change depending on combustion technologies; therefore, it is vital to establish country/technology-specific emission factors.
منابع مشابه
A Study on Methane and Nitrous Oxide Emissions Characteristics from Anthracite Circulating Fluidized Bed Power Plant in Korea
In order to tackle climate change effectively, the greenhouse gas emissions produced in Korea should be assessed precisely. To do so, the nation needs to accumulate country-specific data reflecting the specific circumstances surrounding Korea's emissions. This paper analyzed element contents of domestic anthracite, calorific value, and concentration of methane (CH₄) and nitrous oxide (N₂O) in t...
متن کاملSimulation of a Solid Oxide Fuel Cell with External Steam Methane Reforming and Bypass
Fuel flexibility is a significant advantage of solid oxide fuel cells (SOFCs) and can be attributed to their high operating temperature. The eligibility of a combined heat and power (CHP) system has been investigated as a new power generation methode, in this study. Natural gas fueled SOFC power systems via methane steam reforming (MSR) yield electrical conversion efficiencies exceeding 50% and...
متن کاملOptimal Mixture of Electricity Production Under Uncertainty: Case of Western Azerbaijan Province
In recent years, optimal use of fossil fuels, reduction of environmental pollution and exploitation of renewable energy is one of the most important issues in the policies of different countries, and as you know, Iranchr('39')s electricity industry is dependent on fossil fuel consumption strongly, which causes environmental pollution. The aim of this study is to obtain the optimal combination o...
متن کاملOptimal Mixture of Electricity Production Under Uncertainty: Case of Western Azerbaijan Province
In recent years, optimal use of fossil fuels, reduction of environmental pollution and exploitation of renewable energy is one of the most important issues in the policies of different countries, and as you know, Iranchr('39')s electricity industry is dependent on fossil fuel consumption strongly, which causes environmental pollution. The aim of this study is to obtain the optimal combination o...
متن کاملPotential of municipal solid waste for renewable energy production and reduction of greenhouse gas emissions in South Korea.
Energy from waste (EfW) for nonrecyclable wastes is a suitable method of waste management and is important for renewable energy production. South Korea currently recycles 57% of household waste and landfills 26%. The remaining 17% is incinerated, mainly for heat production. In this study, the potential for energy production and reduction of corresponding greenhouse gas (GHG) emissions from muni...
متن کامل