Modeling and Simulation of Oxygen Precipitation in CZ Silicon

نویسندگان

  • B. G. Ko
  • S. H. Yoon
  • K. D. Kwack
چکیده

This paper describes modeling and simulation for the growth and dissolution of oxygen precipitates in Czochralski silicon(CZ) wafers during heat treatment. Growth and dissolution rates arc newly derived and inserted into a set of chemical rate equations(CILEs) and a Fokkor-Planck equation(FPE). Annealing ambients and surface conditions are taken into account for solving continuity equations in order to calculate oxygon depth profile and oxygen precipitates density more precisely.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effect of Stress on Creation of Defects in Annealed Czochralski Grown Silicon

The effect of stress (exerted by hydrostatic pressure of argon ambient enhanced up to 1.2 GPa) on the creation of oxygen-related defects in annealed Czochralski grown silicon (Cz-Si) was investigated. Concentrations of oxygen interstitials and of dislocations in Cz-Si samples with before-created nucleation centres for oxygen precipitation were markedly lower after pressure treatment at 1120 to ...

متن کامل

Stress-Induced Nitrogen and Oxygen Segregation and Complexing Investigated by High Resolution Synchrotron FTIR

Nitrogen doped Czochralski (N-CZ) and Float Zone (N-FZ) silicon were measured by high resolution synchrotron Fourier Transform IR spectroscopy (HR-FTIR). The chemical complexes were analyzed in specific regions with known extended defects, i.e., denuded or precipitated regions of annealed N-CZ Si wafers, in N-FZ Si with ring defects and on “N-Skin” region. The absorption lines were assigned to ...

متن کامل

Two-Dimensional Diffusion Characterization of Boron in Silicon using Reverse Modeling

This work deals with the simulation of two-dimensional impurity diffusion in CMOS silicon devices. The Reverse Modeling method was used to determine the diffusion coefficient (Dl), surface recombination rate of defects (K,) and the characteristics of the injecting source. Analysis showed similarity between Dl in 2-D system compared with the value obtained from non-patterned samples. The results...

متن کامل

An Observation of Oxygen Precipitation Retardation Phenomenon Induced by 450°c Anneal in Czochralski Silicon

Two-step (450°C-1000°C) and three-step (1150°C-450°C-1000°C) annealing experiments were carried out to study oxygen precipitation behavior in Czochralski silicon. A distinct retardation of precipitation was observed during the two-step anneal, while the retardation during the three-step anneal was less pronounced. With the three-step anneal, the first high temperature 1150°C anneal in N 2 ambie...

متن کامل

Defects in silicon

The method of obtaining pure polycrystalline silicon is described, followed by short accounts of how this material is converted into single-crystal form either by the Czochralski (cz) pulling method or the float-zone (FZ) method. It is shown that the silicon contains various impurities including oxygen, carbon, boron and possibly hydrogen. If a silicon nitride crucible is used instead of silica...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2007