Testing High Speed VLSI Devices Using Slower Testers

The speed of new VLSI designs is rapidly increasing. Assuring the performance of the circuit requires that the circuit be tested at its intended operating speed. The high cost of high speed testers makes it impossible for the testers to follow the designs in terms of speed increase. This gap between the speed of the new circuits and the speed of the testers is not likely to disappear. In this paper , we focus on at-speed strategies for testing high speed designs on slower testers. Conventional at-speed testing strategies assume that the primary inputs/outputs can be applied/observed at the circuit rated speed. This requires a high speed tester. Our assumption is that a fast clock matching the speed of the designs is available. We describe two classes of at-speed strategies that can be used on a low speed tester. The rst class consists of testing schemes for which the test generation procedure is independent of the speed of the tester. These methods apply multiple input patterns in one tester cycle and the test application time for them can be long. The strategies in the second class of at-speed testing schemes integrate the tester's speed limitations with the test generation process. Due to constraints placed at the test generation process, these schemes might result in a reduced fault coverage. To increase the fault coverage and reduce the test application time, the slow-fast-slow and at-speed strategies can be combined for testing high speed designs on slower testers. We present preliminary experimental results for at-speed schemes for slow testers for transition faults.