Tuning diffusion and friction in microscopic contacts by mechanical excitations.

نویسندگان

  • Z Tshiprut
  • A E Filippov
  • M Urbakh
چکیده

We demonstrate that lateral vibrations of a substrate can dramatically increase surface diffusivity and mobility and reduce friction at the nanoscale. Dilatancy is shown to play an essential role in the dynamics of a nanometer-size tip which interacts with a vibrating surface. We find an abrupt dilatancy transition from the state with a small tip-surface separation to the state with a large separation as the vibration frequency increases. Atomic force microscopy experiments are suggested which can test the predicted effects.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Investigating the Effect of Optimum Welding Parameters on the Microstructural and Mechanical Properties of St37 Steel and 316L Stainless Steel Welded by the Friction Stir Welding Process

In this research, St37 and 316L steel sheets were welded using friction stir welding (FSW) process and effective parameters such as the rotational speed, linear speed of the tool, pin diameter, and their appropriate values were studied. The microstructure, hardness, and strength of the different welding regions were investigated. It was observed that in the stir zone (SZ), a mechanical operatio...

متن کامل

Dry Friction and Wear Performance of Micro Surface Textures Generated by Ultrasonic Assisted Face Turning

Nowadays the surface texturing has been widely recognized as a usable capability to improve the tribological systems. In this paper, ultrasonic assisted turning (UAT) isperformed to create the micro textures on the flat faces. Micro surface texturing ismade on the Al7075-T6 by the UAT in the face turning process. Then, the influences of cutting speed feed, vibration direction and vibration ampl...

متن کامل

Dry Friction and Wear Performance of Micro Surface Textures Generated by Ultrasonic Assisted Face Turning

Nowadays the surface texturing has been widely recognized as a usable capability to improve the tribological systems. In this paper, ultrasonic assisted turning (UAT) isperformed to create the micro textures on the flat faces. Micro surface texturing ismade on the Al7075-T6 by the UAT in the face turning process. Then, the influences of cutting speed feed, vibration direction and vibration ampl...

متن کامل

A new multi-switch circuit with adaptive capacitance for semi-active piezoelectric shunt damping

Piezoelectric-based shunt dampers are developed in recent years because of simplicity in comparison with other methods. In these methods, a part of converted mechanical energy is stored in the internal el...

متن کامل

Employing Internal Flexible Wall as Mass Absorber in Tanks Subjected to Harmonic Excitations

The possibility of employing internal wall as mass absorber in rectangular water storage tanks subjected to harmonic ground motion excitation is investigated in this paper. Internal walls are used in these tanks usually for service performance purposes, which could be used as mass absorber to control seismic demand on tank's exterior walls. Derivation of the response of the coupled system inclu...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Physical review letters

دوره 95 1  شماره 

صفحات  -

تاریخ انتشار 2005