Mist/Steam Heat Transfer in Confined Slot Jet Impingement
نویسندگان
چکیده
Internal mist/steam blade cooling technology has been considered for the future generation of Advanced Turbine Systems (ATS). Fine water droplets of about 5 mm were carried by steam through a single slot jet onto a heated target surface in a confined channel. Experiments covered Reynolds numbers from 7500 to 25,000 and heat fluxes from 3 to 21 kW/m. The experimental results indicate that the cooling is enhanced significantly near the stagnation point by the mist, decreasing to a negligible level at a distance of six jet widths from the stagnation region. Up to 200 percent heat transfer enhancement at the stagnation point was achieved by injecting only ;1.5 percent of mist. The investigation has focused on the effects of wall temperature, mist concentration, and Reynolds number. @DOI: 10.1115/1.1331536#
منابع مشابه
Numerical Investigation on Slot air Jet impingement Heat Transfer between Horizontal Concentric Circular Cylinders
A numerical study has been carried out for slot air jet impingement cooling of horizontal concentric circular cylinders. The slot air jet is situated at the symmetry line of a horizontal cylinder along the gravity vector and impinges on the bottom of the outer cylinder which is designated as θ=0°. The outer cylinder is partially opened at the top with a width of W=30mm and is kept at constant t...
متن کاملModeling of Heat Transfer in a Mist/Steam Impinging Jet
The addition of mist to a flow of steam or gas offers enhanced cooling for many applications, including cooling of gas turbine blades. The enhancement mechanisms include effects of mixing of mist with the gas phase and effects of evaporation of the droplets. An impinging mist flow is attractive for study because the impact velocity is relatively high and predictable. Water droplets, less than 1...
متن کاملApplying a full implicit finite-difference method in jet impingement heat transfer studies
Jet impingement heat transfer is an effective and practical approach that is employed in many industrial processes where heating, cooling, or drying is required. Details of the heat or mass transfer rate have been investigated both experimentally and numerically and can be found in the published literature. In most of the numerical studies, control-volume approach has been employed to solve the...
متن کاملThermal Performance of Jet Impingement with Spent Flow Management
The present study proposes novel micro-jet impingement heat sink with effusion holes for flow extraction. The design consists of impingement nozzles surrounded by multiple effusion holes to take away the spent fluid. A three-dimensional numerical model is used for steady, incompressible, laminar flow and conjugate heat transfer for the performance analysis of the proposed design. The computatio...
متن کاملUnsteady Numerical Investigations of Flow and Heat Transfer Characteristics of Nanofluids in a Confined Jet Using Two-Phase Mixture Model
The development of high-performance thermal systems has increased interest in heat transfer enhancement techniques. The application of additives to heat transfer liquids is one of the noticeable effort to enhance heat transfer. In this paper two-dimensional unsteady incompressible nanofluid flow in a confined jet at the laminar flow regime is numerically investigated. The Mixture model is consi...
متن کامل