The selective adsorption of tellurium in the aluminosilicate regions of AFI- and MOR-type microporous crystals.
نویسندگان
چکیده
Attempts have been made to load tellurium (Te) atoms into the one-dimensional nano-channels of microporous crystals of aluminophosphate AlPO4-5 and of aluminosilicate mordenites of the Na(+) form (Na-MOR) and the H(+)-form (H-MOR) at 673 K. The density of the atoms adsorbed was in the sequence 0 ∼ AlPO4-5 ≪ H-MOR < Na-MOR. AlPO4-5 provides a shallow potential of periodical charge fluctuation for Te atoms, from the alternate ordering of Al and P atoms through O atoms. Mordenite offers a sufficiently strong potential for Te adsorption, but the magnitude varies with the type of cation. Dipoles between framework AlO2(-) anion sites and their Na(+) counter-ions in Na-MOR provide a stronger potential than the Brønsted acid points in H-MOR. The adsorption of Te atoms in the silico-aluminophosphate SAPO-5 was between that of AlPO4-5 and H-MOR, leading us to suspect that Te atoms are selectively adsorbed in the aluminosilicate regions accompanying the Brønsted acid points distributed in the major aluminophosphate network. The aluminosilicate regions in SAPO-5 are below 500 nm in size and are distributed throughout a single crystal.
منابع مشابه
Nano-sized AlPO4-5 Crystals: Synthesis and characterization
Molecular sieves and zeolites are materials whose crystalline frameworks form nanometer or subnanometer pores. A variety of different crystal structures are known having a range of pore sizes. Because the pore sizes are usually smaller than 2 nm, they are classified as microporous materials. Synthesis of microporous materials is usually conducted by the high temperature treatment (80-200 °C) of...
متن کاملNano-sized AlPO4-5 Crystals: Synthesis and characterization
Molecular sieves and zeolites are materials whose crystalline frameworks form nanometer or subnanometer pores. A variety of different crystal structures are known having a range of pore sizes. Because the pore sizes are usually smaller than 2 nm, they are classified as microporous materials. Synthesis of microporous materials is usually conducted by the high temperature treatment (80-200 °C) of...
متن کاملStudy of the dynamic adsorption process of toluene by a microporous copper metal-organic framework
Introduction: Toluene is considered as a group of chemical contaminants, causing problems for people’s health. Due to the high rate of evaporation and rapid emission in the surrounding environment, it leads to the exposure of many employees and people at risk and, subsequently, its irreparable effects on their health in different jobs. Therefore, its removal is very important. In the present st...
متن کاملAdsorption behavior studies of Cerium on modified Mesoporous Aluminosilicate
In this paper, the adsorption of cerium on modified Mesoporous aluminosilicate (with Si/Al mole ratio of 10) was studied. The effects of pH, contact time, initial concentration of cerium on adsorption of cerium were investigated. The adsorption capacity was high in the pH range of 4-8 and decreases with decreasing of the pH value. The Langmuir and Freundlich isotherms were applied to represent ...
متن کاملAdsorption behavior studies of Cerium on modified Mesoporous Aluminosilicate
In this paper, the adsorption of cerium on modified Mesoporous aluminosilicate (with Si/Al mole ratio of 10) was studied. The effects of pH, contact time, initial concentration of cerium on adsorption of cerium were investigated. The adsorption capacity was high in the pH range of 4-8 and decreases with decreasing of the pH value. The Langmuir and Freundlich isotherms were applied to represent ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Dalton transactions
دوره 43 37 شماره
صفحات -
تاریخ انتشار 2014