Surface hardness evaluation of different composite
نویسنده
چکیده
1DDS, PhD, Department of Operative Dentistry, School of Dentistry, Istanbul University, Istanbul, Turkey. 2DDS, PhD, Department of Operative Dentistry, School of Dentistry, Istanbul University, Istanbul, Turkey. 3DS, Department of Operative Dentistry, School of Dentistry, Istanbul University, Istanbul, Turkey. 4PhD, Istanbul University School of Medicine, Department of Biostatistics and Medical Informatics, Istanbul, Turkey.
منابع مشابه
Investigating the effect of tool dimension and rotational speed on microstructure of Al-B4C surface composite layer produced by friction stir processing (FSP)
Friction stir processing (FSP) was used for the fabrication of Al-B4C surface composite. Al-Mg-Si alloy was considered as the substrate and B4C particles were incorporated into the substrate by thermo-mechanical effect of FSP. The effect of tool dimensions and different rotational speeds on the microstructure and microhardness of the composite layers was evaluated and the optimum process parame...
متن کاملSYNTHESIS OF FUNCTIONALLY GRADED Al LM25/ZIRCONIA COMPOSITE AND ITS SLIDING WEAR CHARACTERIZATION USING RESPONSE SURFACE METHODOLOGY
Functionally graded aluminium/zirconia metal matrix composite was fabricated using stir casting technique followed by horizontal centrifugal casting process and a hollow cylindrical functionally graded composite (150 x 150 x 16 mm) was obtained with centrifuging speed of 1200 rpm. The microstructural evaluation and hardness test was carried out on the outer and inner surface of the functionally...
متن کاملEvaluation of the Surface Hardness of Composite Resins before and after Polishing at Different Times
PURPOSE The aim of this study was to evaluate the surface hardness of six composite resins: Revolution, Natural Flow, Fill Magic Flow, Flow-it! (flowables), Silux Plus (microfilled) and Z100 (minifilled) before and after polishing at different times. MATERIALS AND METHODS For this purpose, 240 specimens (5mm diameter, 1.4mm high) were prepared. Vickers hardness was determined before and after...
متن کاملIn vitro evaluation of topical fluoride pH and their effect on surface hardness of composite resin-based restorative materials.
AIM The aim of the study was to correlate the pH and fluoride ion uptake with surface hardness of composite resin based restorative materials after topical fluoride application. METHODOLOGY Forty disks of each of test materials Composite (Filtek Z350XT, 3M ESPE, St Paul, MN, USA), Resin modified glass ionomer (Vitremer) and Compomer (Dyract AP) were made and ten disks of each material were pl...
متن کاملمقایسه سختی سطح چهار نوع کامپوزیت بعد از کاربرد دهانشویههای مختلف
Introduction: Plaque control by mechanical method is not sufficient and mouthrinses are highly recomended for patients. Some studies have shown that both of alcohol and alcohol free mouthrinses can reduce the microhardness of restorative materials. This study aimed to investigate the effect of three commercial mouthrinses on the microhardness of four different composite resin. Methods: 60 spec...
متن کاملHardness of composite resin polymerized with different light-curing units
Introduction: The degree of polymerization depends on the type of light-curing unit. The aim of this study was to compare the hardness of composite resin cured by LED and Halogen light curing units. Methods: In this experimental study, 20 cylindrical samples of Tetric Ceram composite were prepared. Half of them were cured with Ultralume 2 LED and the other half with Astralis 7 Halogen light ...
متن کامل