Elastic-plastic Mode-ii Fracture of Adhesive Joints
نویسندگان
چکیده
A numerical study of the elastic-plastic mode-II fracture of adhesive joints is presented in this paper. A traction-separation law was used to simulate the mode-II interfacial fracture of adhesively-bonded end-notched flexure (E.N.F.) specimens loaded in three-point bending, with extensive plastic deformation accompanying failure. The fracture parameters for the traction-separation law were determined by comparing the numerical and experimental results for one particular geometry. These parameters were then used without further modification to simulate the fracture of other E.N.F. specimens with different geometries. It was found that the numerical predictions for the loads and deformation were in excellent agreement with the corresponding experimental results.
منابع مشابه
Mixed-mode Fracture Analyses of Plastically- Deforming Adhesive Joints
A mode-dependent embedded-process-zone (EPZ) model has been developed and used to simulate the mixed-mode fracture of plastically deforming adhesive joints. Mode-I and mode-II fracture parameters obtained from previous work have been combined with a mixed-mode failure criterion to provide quantitative predictions of the deformation and fracture of mixed-mode geometries. These numerical calculat...
متن کاملOn the Toughness of Ductile Adhesive Joints
Crack propagation along one of the interfaces between a thin ductile adhesive layer and the elastic substrates it joins is considered. The layer is taken as being elastic-plastic, and the fracture process of the interface is modeled by a traction-separation law, characterized by the peak separation stress 6 and the work of separation per unit area To. Crack growth resistance curves for mode I l...
متن کاملEffects of substrate material on fracture toughness measurement in adhesive joints
To understand the effects of substrate materials on the fracture behavior of adhesive joints, experimental studies and finite element analyses have both been conducted for double-cantilever-beams (DCB) with aluminum and steel substrates at different bond thickness (h). Numerical results show that the region dominated by the crack singularity is much smaller than the bond thickness. Very small p...
متن کاملFracture Resistance and Failure Mode of Endodontically Treated Premolars Restored with Different Adhesive Restorations
Introduction: The restoration of endodontically treated teeth is a topic that has been studied extensively but it is still a challenge for dental practitioners. The aim of this study was to evaluate fracture resistance, fracture patterns and fracture location of endodontically treated human maxillary premolars restored with direct and indirect composite resin and ceramic restoration. Methods: E...
متن کاملFinite Element Modeling for Thermal Stresses Developed in Riveted and Rivet - Bonded Joints
A three-dimensional finite element modeling is developed using ABAQUS software. This includes riveted and rivet-bonded joints models. Both models undergo thermal heat caused by hot-driven rivet process and then are subjected to a constant velocity at one of its strip edges to simulate the shear tensile test up to the failure point. The developed FE models were based on elastic-plastic propertie...
متن کامل