High-repetition-rate polymeric solid-state dye lasers pumped by a copper-vapor laser
نویسندگان
چکیده
We report on the laser action of pyrromethene 567 incorporated into polymeric matrices and pumped longitudinally with the green line of a copper-vapor laser. When the dye was dissolved in a copolymer of methyl methacrylate and pentaerythritol triacrylate, 290 mW average power at 1 kHz ~37% lasing efficiency! was obtained. The laser output decreased to 150 mW after 30 min irradiation time (1.8310 shots) and to 32 mW after 70 min of operation (4.2310 shots). Output power of up to 1 W at 6.2 kHz was obtained for short periods of time. Polymeric matrices incorporating rhodamine 6G were also studied. © 2001 American Institute of Physics. @DOI: 10.1063/1.1385585#
منابع مشابه
Enhanced laser action of Perylene-Red doped polymeric materials.
The laser action of Perylene-Red doped in linear, crosslinked, fluorinated and sililated polymeric materials is reported. The purity of dye was found to be a key factor to enhance its solid-state laser behaviour. The samples were transversely pumped at 532 nm, with 5.5 mJ/pulse and 10 Hz repetition rate. Perylene-Red doped copolymers of methyl methacrylate with a 10 vol% proportion of 2,2,2-tri...
متن کاملDiode-Pumped Solid State Lasers
III The use ofdiode lasers instead ofHashlamps as optical pump sources for solid state lasers offers significant advantages such as higher efficiency and longer lifetime. We have demonstrated three novel lasers based on this technology. The first is a zig-zag slab laser pumped by hybrid planar microchannel-cooled diode arrays that allow high-repetition-rate operation in a pulsed mode. The secon...
متن کاملDiode-pumped mode-locked femtosecond 2-μm Tm:CaYAlO4 laser
Continuous-wave mode-locked femtosecond 2-m solid-state laser with a c-cut Tm:CaYAlO4 (6 at.%) as gain medium was experimentally demonstrated. The mode locked laser generated stable pulses with average output power as high as 531 mW, pulse duration of 496 fs, and repetition rate of 97 MHz at 1975 nm. The research results show that Tm:CaYAlO4 is an excellent gain medium for femtosecond pulse ge...
متن کاملstate compact high repetition rate ked Cr 4 + : YAG laser
operated stably after more than 500h. In conclusion, we obtained a nearly round FFP in the 650nm band wavelength using the S3-laser. The laser had good I-L characteristics and good reliability at lOmW and 60°C. We consider that the laser could be of use as a light source in optical disk systems. and TERAMOTO, I.: 'Novel technology for formation of a narrow active layer in buried heterostructure...
متن کاملDevelopment and application of new high-power laser beam sources
The actual market volume of high-power lasers for manufacturing is dominated by diffusion cooled CO2 laser systems at the multi-kW range and lamp pumped Nd:YAG laser systems at the kW range. Substituting the lamps by diodes the Nd:YAG laser in rod design entered the market as diode pumped solid state laser of the first generation. With output powers up to 6 kW the diode pumped rod is used in in...
متن کامل