The test analysis of transmission gears’ fatigue pitting
نویسندگان
چکیده
There were severe pitting corrosions on the surface of transmission gears in diesels. The cause of metal fatigue pitting of gear surface is analyzed in the paper, which based on the contact fatigue experiment of 18Cr2Ni4WA carburizing and quenching gears used in the diesel engine. Causes of pitting on harden tooth surface are studied from three aspects: gear surface residual stress field, oil film pressure and carburizing thickness, which according to the morphology of test gear fatigue fracture and the surface hardening properties of carburizing and quenching gears. The reasons of experimental gears' contact fatigue pitting were analyzed and conclusions were as follows: The depth of the diffusion layer, surface carbon concentration and the carbon concentration gradient of layer were the key to improve the ability to resist wear surface fatigue pitting.
منابع مشابه
Gear Fault Detection Effectiveness as Applied to Tooth Surface Pitting Fatigue Damage
A study was performed to evaluate fault detection effectiveness as applied to gear tooth pitting fatigue damage. Vibration and oil-debris monitoring (ODM) data were gathered from 24 sets of spur pinion and face gears run during a previous endurance evaluation study. Three common condition indicators (RMS, FM4, and NA4) were deduced from the time-averaged vibration data and used with the ODM to ...
متن کاملContact Fatigue
CONTACT FATIGUE is a surface-pitting-type failure commonly found in ball or roller bearings. This type of failure can also be found in gears, cams, valves, rails, and gear couplings. Contact fatigue has been identified in metal alloys (both ferrous and nonferrous) and in ceramics and cermets. Contact fatigue differs from classic structural fatigue (bending or torsional) in that it results from ...
متن کاملThe source of Acoustic Emission during meshing of spur gears
Condition monitoring of gears with vibration analysis and Spectrometric Oil Analysis Programs (SOAP) are widely accepted and used in the military aviation industry. Whilst the literature to date has shown the application of the Acoustic Emission (AE) technique to gearbox health monitoring still be in its infancy, there exist opportunities to develop the technique into a complementary diagnostic...
متن کاملIntegrating Oil Debris and Vibration Gear Damage Detection Technologies Using Fuzzy Logic
A diagnostic tool for detecting damage to spur gears was developed. Two different measurement technologies, wear debris analysis and vibration, were integrated into a health monitoring system for detecting surface fatigue pitting damage on gears. This integrated system showed improved detection and decision-making capabilities as compared to using individual measurement technologies. This diagn...
متن کاملDiagnosis of the Wear of Gears in the Gearbox Using the Wavelet Packet Transform
T. Figlus, M. Stańczyk, The Silesian University of Technology, Faculty of Transport, Katowice, Poland The paper presents research aimed at diagnosing early cases of wear of gears tooth surface in the gearbox based on measurements of vibration signals and their processing using the wavelet packet transform. Analysis concerned the vibration signals recorded in a test bench experiment, during whic...
متن کامل