Flexible Optical Waveguides for Uniform Periscleral Cross-Linking
نویسندگان
چکیده
Purpose Scleral cross-linking (SXL) with a photosensitizer and light is a potential strategy to mechanically reinforce the sclera and prevent progressive axial elongation responsible for severe myopia. Current approaches for light delivery to the sclera are cumbersome, do not provide uniform illumination, and only treat a limited area of sclera. To overcome these challenges, we developed flexible optical waveguides optimized for efficient, homogeneous light delivery. Methods Waveguides were fabricated from polydimethylsiloxane elastomer. Blue light (445 nm) is coupled into the waveguide with an input fiber. Light delivery efficiency from the waveguide to scleral tissue was measured and fit to a theoretical model. SXL was performed on fresh porcine eyes stained with 0.5% riboflavin, using irradiances of 0, 25, and 50 mW/cm2 around the entire equator of the eye. Stiffness of scleral strips was characterized with tensiometry. Results Light delivery with a waveguide of tapered thickness (1.4-0.5 mm) enhanced the uniformity of light delivery, compared to a flat waveguide, achieving a coefficient of variation of less than 10%. At 8% strain, sclera cross-linked with the waveguides at 50 mW/cm2 for 30 minutes had a Young's modulus of 10.7 ± 1.0 MPa, compared to 5.9 ± 0.5 MPa for no irradiation, with no difference in stiffness between proximally and distally treated halves. The stiffness of waveguide-irradiated samples did not differ from direct irradiation at the same irradiance. Conclusions We developed flexible waveguides for periscleral cross-linking. We demonstrated efficient and uniform stiffening of a 5-mm-wide equatorial band of scleral tissue.
منابع مشابه
3D optical waveguides produced by two photon photopolymerisation of a flexible silanol terminated polysiloxane containing acrylate functional groups
Optical waveguides are becoming increasingly important in the developing area of broadband communications. The field of electronics is advancing rapidly, leading to further demands for larger data storage, smaller components and a better design of integrated optical circuits. The integration of optical interconnects on printed circuit boards (PCBs) requires precise technologies to make this eme...
متن کاملOptical pulse compression based on nonlinear silicon waveguides and chirped Bragg gratings
Due to the growing demand for higher bandwidth, employing optical devices instead of electronic devices in data transmission systems has attracted much attention in recent years. Optical switches, modulators and wavelength converters are a few examples of the required optical devices. CMOS compatible fabrication of these devices, leads to much more growing of this technology. Optical pulse comp...
متن کاملOptimized Digital Optical Switch Using Proton Exchanged Lithium Niobate Waveguides
The main emphasis in developing DOS has been on achieving low crosstalk (CT). CT in the order of -30 dB is acceptable in conventional DOS and below that value is hard to achieve. Relatively low drive voltage (or power requirements) is also necessary to optimized DOS. This paper depicts the design of Y-branched digital optical switches (DOS) with optimized on-chip area coverage, reduced driving ...
متن کاملFlexible, Stable, and Easily Processable Optical Silicones for Low Loss Polymer Waveguides
Photopatternable optical silicone materials have been developed that can be fabricated into flexible polymer waveguides using conventional film processing and photolithography techniques. Waveguides designed for multimode applications have demonstrated loss of 0.05 dB/cm at 850 nm. These waveguides have proven stable in 85% relative humidity and 85 C storage conditions for greater than 2000 ho...
متن کاملOptical waveguides with apodized sidewall gratings via spatial-phase- locked electron-beam lithography
We describe a technique to fabricate Bragg gratings in the sides of optical waveguides using a single lithographic step. This technique is particularly suited to the apodized gratings required for add/drop filters in dense-wavelength-division multiplexing. Apodization minimizes cross talk between channels and improves the filter response. Silicon-on-insulator rib waveguides with both uniform an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره 58 شماره
صفحات -
تاریخ انتشار 2017