Solid-State Bipolar Marx Generator with Voltage Droop Compensation
نویسندگان
چکیده
This paper addresses the voltage droop compensation associated with long pulses generated by solid-stated based high-voltage Marx topologies. In particular a novel design scheme for voltage droop compensation in solid-state based bipolar Marx generators, using low-cost circuitry design and control, is described. The compensation consists of adding one auxiliary PWM stage to the existing Marx stages, without changing the modularity and topology of the circuit, which controls the output voltage and a LC filter that smoothes the voltage droop in both the positive and negative output pulses. Simulation results are presented for 5 stages Marx circuit using 1 kV per stage, with 1 kHz repetition rate and 10% duty cycle.
منابع مشابه
Voltage Droop Compensation for Marx Modulators*
Marx modulators operated by solid-state switches (e.g. MOSFET, IGBT) offer an alternative to traditional high voltage (HV) modulators for rf power sources. They have the merits of compact size, high-energy efficiency, high reliability, pulse width control and cost reduction. However, Marx modulators need a complex voltage compensation circuit if they are employed in long pulse applications such...
متن کاملA High Gain Bipolar Pulse Generator with Low Voltage Input Source
This paper proposes a pulsed power generator which consists of two types of switched-capacitor booster modules. A doubling mode module employed to elevate the input voltage to a specified level and, constant mode module is used to increase the elevated voltage into the finally intended bipolar output voltage. Also, the proposed modular structure does not utilize any switches across the load. Ot...
متن کاملPortable Marx Generator for Microplasma Applications
There are many applications using pulsed power such as the triggering of high speed cameras and spectrometers, the processing or chemical analysis of minute material, and the stimulation of cells by electrical pulses. The pulse width and voltage required for each application are different in the range of ns and kV. The energy required is usually in the mJ regime. Here, a novel portable pulse po...
متن کاملVoltage Imbalance Compensation for Droop-Controlled Inverters in Islanded Microgrid
In this paper, a new control strategy is proposed for implementation in low-voltage microgrids with balanced/ unbalanced load circumstances. The proposed scheme contains, the power droop controllers, inner voltage and current loops, the virtual impedance loop, the voltage imbalance compensation. The proposed strategy balances the voltage of the single-phase critical loads by compensating the im...
متن کاملEUROPEAN ORGANIZATION FOR NUCLEAR RESEARCH European Laboratory for Particle Physics
A semiconductor solid state switch has been constructed and tested in the prototype extraction kicker pulse generator of CERN's Large Hadron Collider (LHC) [1]. The switch is made of 10 modified 4.5 kV, 66 mm symmetric GTO's (also called FHCT-Fast High Current Thyristor), connected in series. It holds off a d.c. voltage of 30 kV and conducts a 5 μs half-sine wave current of 20 kA with an initia...
متن کامل