Pumps—Shaft Sealing Systems for Centrifugal and Rotary Pumps
ثبت نشده
چکیده
This standard specifies requirements and gives recommendations for sealing systems for centrifugal and rotary pumps used in the petroleum, natural gas, and chemical industries. See A.1.1 and A.1.2. It is the responsibility of the purchaser or seal vendor to ensure that the selected seal and auxiliaries are suitable for the intended service condition. It is applicable mainly for hazardous, flammable, and/or toxic services where a greater degree of reliability is required for the improvement of equipment availability and the reduction of both emissions to the atmosphere and life-cycle sealing costs. It covers seals for pump shaft diameters from 20 mm (0.75 in.) to 110 mm (4.3 in.).
منابع مشابه
Method of Evaluation of Efficiency Improvement Potential for District Heating Systems with Focus on Variable Speed Centrifugal Pumps
The goal of this research is the derivation of method for evaluation of efficiency improvement potential for district heating systems with focus on variable speed centrifugal pump. The effectiveness of the usage of the proportional pressure control is compared with the constant pressure control. This is why, energy calculation analyses have been realized for variable speed centrifugal pumps, an...
متن کاملConsiderations for Dual Pressurized Gas Seals in Pump Applications
Mechanical seals continue to be the predominant technology for shaft sealing in centrifugal pumps and other rotating equipment. While most mechanical seals are designed to operate on a liquid film, there are options for designing seal faces which function reliably while operating on a hydrodynamic gas film. In a dual pressurized seal (Arrangement 3), gas seals can provide unique benefits in ter...
متن کاملAn Experimental Study of the Shaft Oil Supply Mechanism of a Rotary Compressor
This paper describes the experimental study of the shaft oil feed mechanism of a rotary compressor. The oil contained in the shaft in which an oil pump is inserted is fed to the respective sliding surfaces of the subbearing section, eccentric section and main bearing section of the shaft by centrifugal force of shaft rotation. The oil feed pressure of shaft rotation is approximately 0.1 kg/cm2 ...
متن کاملTheoretical, Scientific and Practical Aspects of the Basic Stages of Cad Cam Designing of Centrifugal Pumps
Many theoretical and practical problems arise at different stages of the design/manufacturing process during development of a pump. The experience obtained in pump development proves that the quality of a pump depends on many factors, which should he satisfied to receive good results. At the same time, the theory of engineering design principles exists, which is applicable to designing various ...
متن کاملUpthrust Problems on Multistage Vertical Turbine Pumps
Vertical turbine pumps are designed to operate with the pump shafts in tension (downthrust). Most pump and motor manufacturers caution users to not operate the vertical turbine pumps at conditions that result in “upthrust.” Upthrust conditions are usually encountered for a few seconds each time the pump is started; however, the pump should not be operated for periods longer than a few seconds i...
متن کامل