Development and Operation of an Automatic Rotor Trim Control System for the UH-60 Individual Blade Control Wind Tunnel Test
نویسندگان
چکیده
An automatic rotor trim control system was developed and successfully used during a wind tunnel test of a full-scale UH-60 rotor system with Individual Blade Control (IBC) actuators. The trim control system allowed rotor trim to be set more quickly, precisely and repeatably than in previous wind tunnel tests. This control system also allowed the rotor trim state to be maintained during transients and drift in wind tunnel flow, and through changes in IBC actuation. The ability to maintain a consistent rotor trim state was key to quickly and accurately evaluating the effect of IBC on rotor performance, vibration, noise and loads. This paper presents details of the design and implementation of the trim control system including the rotor system hardware, trim control requirements, and trim control hardware and software implementation. Results are presented showing the effect of IBC on rotor trim and dynamic response, a validation of the rotor dynamic simulation used to calculate the initial control gains and tuning of the control system, and the overall performance of the trim control system during the wind tunnel test.
منابع مشابه
Design and Performance Prediction of Swashplateless Helicopter Rotor with Trailing Edge Flaps and Tabs
Title of dissertation: DESIGN AND PERFORMANCE PREDICTION OF SWASHPLATELESS HELICOPTER ROTOR WITH TRAILING EDGE FLAPS AND TABS Jaye Falls, Doctor of Philosophy, 2010 Dissertation directed by: Professor Inderjit Chopra Department of Aerospace Engineering This work studies the design of trailing edge controls for swashplateless helicopter primary control, and examines the impact of those controls ...
متن کاملTitle of dissertation: COMPREHENSIVE AEROELASTIC ANALYSIS OF HELICOPTER ROTOR WITH TRAILING-EDGE FLAP FOR PRIMARY CONTROL AND VIBRATION CONTROL
Title of dissertation: COMPREHENSIVE AEROELASTIC ANALYSIS OF HELICOPTER ROTOR WITH TRAILING-EDGE FLAP FOR PRIMARY CONTROL AND VIBRATION CONTROL Jinwei Shen, Doctor of Philosophy, 2003 Dissertation directed by: Professor Inderjit Chopra Department of Aerospace Engineering A comprehensive aeroelastic analytical model of helicopter rotors with trailingedge flaps for primary and vibration controls ...
متن کاملExperimental Investigation ofthe Hovering Performance of aTwin-Rotor Test Model
Hover performance of a twin-rotor test model in terms of rotor overlap sweep, blade collective pitch, and blade tip speedwasexaminedexperimentally.The experimental setup consisted of two three-bladed rotors (tandem rotor configuration) with a diameter of1,220 mm and constant chord of 38 mm, giving a blade aspect ratio of 16.05. The blades were of a rectangular planform with NACA 0012 cross-sect...
متن کاملHelicopter Rotor Design Using a Time-Spectral and Adjoint-Based Method
A time-spectral and adjoint-based optimization procedure that is particularly efficient for the analysis and shape design of helicopter rotors is developed. The time-spectral method is a fast and accurate algorithm to simulate periodic, unsteady flows by transforming them to a steady-state analysis using a Fourier spectral derivative temporal operator. An accompanying steady-state adjoint formu...
متن کاملDesign of a Wind Tunnel Scale Model of an Adaptive Wind Turbine Blade for Active Aerodynamic Load Control Experiments
Within wind energy research there is a drive towards the development of a “smart rotor”; a rotor of which the loading can be measured and controlled through the application of a sensor system, a control system and an aerodynamic device. Most promising solutions from an aerodynamic point of view are trailing edge flaps, either hinged or continuously deformable. An experiment was considered neces...
متن کامل