Abnormal correlation between phase transformation and cooling rate for pure metals
نویسندگان
چکیده
This work aims to achieve deep insight into the phenomenon of phase transformation upon rapid cooling in metal systems and reveal the physical meaning of scatter in the time taken to reach crystallization. The total number of pure metals considered in this work accounts for 14. Taking pure copper as an example, the correlation between phase selection of crystal or glass and cooling rate was investigated using molecular dynamic simulations. The obtained results demonstrate that there exists a cooling rate region of 6.3 × 10(11)-16.6 × 10(11) K/s, in which crystalline fractions largely fluctuate along with cooling rates. Glass transformation in this cooling rate region is determined by atomic structure fluctuation, which is controlled by thermodynamic factors. According to the feature of bond-orientation order at different cooling rates, we propose two mechanisms of glass formation: (i) kinetic retardation of atom rearrangement or structural relaxation at a high cooling rate; and (ii) competition of icosahedral order against crystal order near the critical cooling rate.
منابع مشابه
Cooling rate optimization of as-cast consciously cast steel
Abstract: A combination of a finite element method (FEM) algorithm with ANSYS codes and post image processing of NDT ultrasonic images along with laboratory cooling experiments and microstructural analysis provide a guideline to determine the optimum cooling rate for any grade of steel in which the highest productivity can be achieved without any degradation of the cast steel products. The sugg...
متن کاملMicrostructural Evaluation of Ti-6AL-4V Alloy during Hot Deformation
Among the titanium alloys, Ti-6Al-4V is the most widely used. In the present work, the uniaxial hot compressive behavior of Ti-6Al-4V has been investigated under constant strain rates. A series of dilatometery experiments were carried out to determine the transformation temperatures at different cooling rates. Specimens were homogenized at 1050 °C for 10 minutes followed by fast cooling to dif...
متن کاملTHE EFFECT OF COOLING RATE AND AUSTENITE GRAIN SIZE ON THE AUSTENITE TO FERRITE TRANSFORMATION TEMPERATURE AND DIFFERENT FERRITE MORPHOLOGIES IN MICROALLOYED STEELS
Abstract: transformation temperature and different ferrite morphologies in one Nb-microalloyed (HSLA) steel has beeninvestigated. Three different austenite grain sizes were selected and cooled at two different cooling rates for obtainingaustenite to ferrite transformation temperature. Moreover, samples with specific austenite grain size have beenquenched, partially, for investigation on the mic...
متن کاملMicrostructural Evaluation of Ti-6AL-4V Alloy during Hot Deformation
Among the titanium alloys, Ti-6Al-4V is the most widely used. In the present work, the uniaxial hot compressive behavior of Ti-6Al-4V has been investigated under constant strain rates. A series of dilatometery experiments were carried out to determine the transformation temperatures at different cooling rates. Specimens were homogenized at 1050 °C for 10 minutes followed by fast cooling to dif...
متن کاملEffect of Amorphous Silica Addition on Martensitic Phase Transformation of Zirconia and Investigation of its Tetragonal Structure Stability Mechanisms
This work is focused on the effect of amorphous SiO2 addition on the phase transformation and microstructural evolution of ZrO2 particles. Considering the structural similarities between the amorphous ZrO2 and its tetragonal structure, XRD results showed initial nucleation of metastable tetragonal ZrO2 from its amorphous matrix upon heat treatment. This metastable phase is unstable in pure ZrO2...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره 6 شماره
صفحات -
تاریخ انتشار 2016