Two-output Class E Isolated dc-dc Converter at 5 MHz Switching Frequency
نویسنده
چکیده
This paper presents a two output class-E isolated dcdc converter that regulates the output voltages at fixed switching frequency. The converter is simulated at operating frequency of 5 MHz. The converter output power is 40 W and the output voltages are 15 V and 5 V. All the switches operate at zero voltage switching (ZVS) conditions for the full load range. The circuit configuration is simple with small passive components which reduce the size of the converter. The circuit also has very good cross-regulation and an inherent short circuit protection with preserved ZVS conditions.
منابع مشابه
A ZVS Flyback DC-DC Converter using Multilayered Coreless Printed-Circuit Board(PCB) Step-down Power Transformer
The experimental and theoretical results of a ZVS (Zero Voltage Switching) isolated flyback DC-DC converter using multilayered coreless PCB step down 2:1 transformer are presented. The performance characteristics of the transformer are shown which are useful for the parameters extraction. The measured energy efficiency of the transformer is found to be more than 94% with the sinusoidal input vo...
متن کاملResonant dc/dc Converter with Class DE Inverter and Class E Rectifier Using Thinned-Out Method (Deleting Some of the Pulses to the Rectifier)
The Class DE inverter offers high-efficiency power conversion under high operating frequency (megahertz order) with low switching noises and low switch voltage stress. It has been applied to dc/dc converters as high-density power sources. Conventional converters with the Class DE inverter are controlled by varying the operating frequency, the switch duty ratio or the phase difference with two i...
متن کاملSimulation and Experimental Verification of Closed Loop Operation of Buck / Boost DC-DC Converter with Soft Switching
A major problem in an isolated DC/DC converters operating at high switching frequencies is the attendant switching losses in the semiconductor devices. This can be reduced by introducing either zero-voltage switching (ZVS) or zero-current switching (ZCS) of the semiconductor switches. This paper deals with the simulation, design, fabrication and experimental evaluation of a novel soft-switching...
متن کاملA High Efficiency Low-Voltage Soft Switching DC–DC Converter for Portable Applications
This paper presents a novel control method to improve the efficiency of low-voltage DC-DC converters at light loads. Pulse Width Modulation (PWM) converters have poor efficiencies at light loads, while pulse frequency modulation (PFM) control is more efficient for the same cases. Switching losses constitute a major portion of the total power loss at light loads. To decrease the switching losses...
متن کاملSliding Mode Control of a Bidirectional Buck/Boost DC-DC Converter with Constant Switching Frequency
In this paper, sliding mode control (SMC) for a bidirectional buck/boost DC-DC converter (BDC) with constant frequency in continuous conduction mode (CCM) is discussed. Since the converter is a high-order converter, the reduced-order sliding manifold is exploited. Because of right-half-plan zero (RHPZ) in the converter’s duty ratio to output voltage transfer function, sliding mode current...
متن کامل