Fabrication Processes for Integrated Circuits

Fabrication Processes for Integrated Circuits

Development of a Dynamic Population Balance Plant Simulator for Mineral Processing Circuits

Operational variables of a mineral processing circuit are subjected to different variations. Steady-statesimulation of processes provides an estimate of their ideal stable performance whereas their dynamicsimulation predicts the effects of the variations on the processes or their subsequent processes. In thispaper, a dynamic simulator containing some of the major equipment of mineral processing...

Dual-Band Evanescent-Mode Substrate Integrated Waveguide Band-pass Filter for WLAN Applications

A new multi-layer substrate integrated waveguide (SIW) structure is developed to design dual-band evanescent-mode band-pass filters (BPFs). Two independent series LC circuits are implemented by incorporating metallic irises in the different layers of the structure. The combination of the metallic irises with capacitive-plates is embedded inside the SIW to independently excite two evane...

A MEMS Capacitive Microphone Modelling for Integrated Circuits

In this paper, a model for MEMS capacitive microphone is presented for integrated circuits.  The microphone has a diaphragm thickness of 1 μm, 0.5 × 0.5 mm2 dimension, and an air gap of 1.0 μm. Using the analytical and simulation results, the important features of MEMS capacitive microphone such as pull-in voltage and sensitivity are obtained 3.8v and 6.916 mV/Pa, respectively while there is no...

Design and Fabrication of Ultralight High-Voltage Power Circuits for Flapping-Wing Robotic Insects

Flapping-wing robotic insects are small, highly maneuverable flying robots inspired by biologicalinsects and useful for a wide range of tasks, including exploration, environmental monitoring, searchand rescue, and surveillance. Recently, robotic insects driven by piezoelectric actuators have achievedthe important goal of taking off with external power; however, fully autonomous operation requir...