Metal Ion Implanted Compliant Electrodes in Dielectric Electroactive Polymer (EAP) Membranes
نویسندگان
چکیده
One of the key factors to obtain large displacements and high efficiency with dielectric electroactive polymer (DEAPs) actuators is to have compliant electrodes. Attempts to scale DEAPs down to the mm or micrometer range have encountered major difficulties, mostly due to the challenge of micropatterning sufficiently compliant electrodes. Simply evaporating or sputtering thin metallic films on elastomer membranes produces DEAPs whose stiffness is dominated by the metallic film. Low energy metal ion implantation for fabricating compliant electrodes in DEAPs presents several advantages: a) it is clean to work with, b) it does not add thick passive layers, and c) it can be easily patterned. We use this technology to fabricate DEAPs micro-actuators whose relative displacement is the same as for macro-scale DEAPs. With transmission electron microscope (TEM) we observed the formation of metallic clusters within the elastomer (PDMS) matrix, forming a nano-composite. We focus our studies on relating the properties of this nano-composite to the implantation parameters. We identified the optimal implantation parameters for which an implanted electrode presents an exceptional combination of high electrical conductivity and low compliance.
منابع مشابه
Ecole P
Miniaturizing chip, combin electroactive Low-energy consisting of up to 175%, excellent adh with µm to m membrane siz actuators, mm actuators to a The term " ar remarkable m shows schem between two between the Depending on blimps [6] , to h Figure 1: the e From * herbert. niaturize Polytechniq g dielectric el ning dozens t polymer (EA (2-10 keV) im a buried 20 n 2) are pattern hesion since im m...
متن کاملMicrofabrication and characterization of an array of dielectric elastomer actuators generating uniaxial strain to stretch individual cells
Cells regulate their behavior in response to mechanical strains. Cell cultures to study mechanotransuction are typically cm2 in area, far too large to monitor single cell response. We have developed an array of dielectric elastomer microactuators as a tool to study mechanotransduction of individual cells. The array consists of 72 100 μm × 200 μm electroactive polymer actuators which expand unia...
متن کاملVoltage tuning of the resonance frequency of electroactive polymer membranes over a range of more than 75% [7362-14]
We report on a novel technique to control the resonance frequency of polymer membranes, without additional external actuators. An electrostatic force is used to apply compressive stress to a dielectric electroactive polymers membrane, consisting of a 25 micron thick, 1 to 4 mm diameter, polydimethylsiloxane (PDMS) film bonded onto patterned silicon or Pyrex wafers. Both sides of the membranes a...
متن کاملIon-implanted compliant and patternable electrodes for miniaturized dielectric elastomer actuators
This article presents metal ion implantation as an alternative technique to fabricate compliant electrodes for small-size dielectric elastomer actuators. When reducing the size of these actuators to below 1 cm, the ability to pattern the electrodes is added to the need for compliance. Metal ion implantation on Polydimethylsiloxane (PDMS) layers allows the creation of conductive and compliant el...
متن کاملArray of lenses with individually tunable focal-length based on transparent ion-implanted EAPs [7642-92]
We report on the fabrication and characterization of 2x2 arrays of mm-diameter PDMS lenses whose focal length can be electrically tuned. Dielectric elastomer actuators generally rely on carbon powder or carbon grease electrodes, which are not transparent, precluding the polymer actuator from also being a lens. However compliant electrodes fabricated by low-energy ion implantation are over 50% t...
متن کامل