Experimental Study of Upsetting and Die Forging with Controlled Impact
نویسندگان
چکیده
The results from experimental research of deformation by upsetting and die forging of lead specimens wit controlled impact are presented. Laboratory setup for conducting the investigations, which uses cold rocket engine operated with compressed air, is described. The results show that when using controlled impact is achieving greater plastic deformation and consumes less impact energy than at ordinary impact deformation process. Keywords—Rocket Engine, Forging Hammer, Sticking Impact, Plastic Deformation.
منابع مشابه
Open-Die Forging of Structurally Porous Sandwich Panels
Structurally porous metal sandwich panels consisting of dense face sheets and porous cores of controlled relative density can be manufactured by trapping inert gas during hot isostatic pressing and modifying its distribution via subsequent thermomechanical forming. A plane-strain solution for analyzing the open-die forging of such a plastically compressible sandwich panel is developed. An effec...
متن کاملOptimization of Flash, Billet Dimensions and Friction Factor in Closed Die Cold Forging Process
Three important parameters in designing a closed die for forging process are ratio of width to flash thickness, ratio of height to billet diameter and the friction factor. In this paper the influences of these parameters on the required force for the forging and percentage of die filling were investigated. It was found that by controlling the flash dimension, the material loss is reduced and t...
متن کاملThe Review Study of Forging and Effects on the Produced Part
There are several method for forming bulk material, such as forging, rolling and extrusion. Every of these methods have advantages and dis-advantages of their selves. Forging process is one of the most common of them that include a die, press and in some case heater with controlling system, and has a special place in automotive, military and aerospace industries due uniformity of the final prod...
متن کاملDetermination of Load and Strain-Stress Distributions in Hot Closed Die Forging Using the Plasticine Modeling Technique
An axisymmetric hot closed die-forging process has been studied by physical modeling technique using the plasticine. To observe the material flow pattern, layers of plasticine with different colors were used. The normal direction to the layers was considered a principal direction. The strain distribution was obtained by measuring the thickness of the plasticine layers. Based on the strain distr...
متن کاملForging Process Control by Additional Rocket Force
Technological processes such as forging, die forging, and pile driving are realized as a result of a collision between two bodies. After the impact the bodies’ energy transforms to plastic or elastic deformations of the colliding bodies. This paper studies both theoretically and experimentally the influence of impact parameters such as forces, accelerations, velocities, time and energy on defor...
متن کامل