A Mechanical and Functional Study of Bone Rods from the Richey–Roberts Clovis Cache, Washington, U.S.A

نویسندگان

  • R. Lee Lyman
  • Michael J. O’Brien
  • Virgil Hayes
چکیده

Bone and ivory (osseous) rods of Paleoindian age have been found over much of North America, several from the same contexts that produced Clovis points. Previous researchers have suggested that these artefacts were projectile points, foreshafts, pressure-flaker handles or sled shoes. Published morphometric data indicate that the rods display varied attribute combinations, but these data are not consistently reported, and no set of typologically definitive attributes has been established. It also is unclear which attributes of the rods are related mechanically to rod function. Experimental replication and mechanical testing of the functional interrelations of numerous attributes of the 14 fluted Clovis points and 14 bone rods recovered from the Richey–Roberts Clovis cache in eastern Washington led to the conclusion that the rods from this site served a primary function as levered hafting wedges used to tighten sinew binding on saw-like implements. ? 1998 Academic Press

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

RESPONSE OF METACARPAL FRACTURE FIXATION CONSTRUCTS TO PHYSIOLOGICAL LOADINGS

This study compares the functional capabilities of different metacarpal fixation constructs under physiological loadings in an attempt to identify the optimal construct rather than the strongest one. One hundred and twenty-six preserved human metacarpals were mechanically tested after oblique osteotomies and internal fixation. Maximum load to failure, average structural rigidity, and energ...

متن کامل

Study of the Effects of Lacing Rods Location on Natural Frequencies in Last Stage Blades of a Steam Turbine

In this study, effects of lacing rods location on natural frequencies of last stage of a Steam Turbine Blades (STBs) have been investigated. STBs are critical and important elements in a turbine as well as power plants. One of the most important parameters in turbine blades is lacing rods location. In this paper, first, a three dimensional (3D) scan was used to produce the geometrical model of ...

متن کامل

Heat transfer enhancement in a spiral plate heat exchanger model using continuous rods

This study presents an innovative and simple way to increase the rate of heat transfer in a spiral plate heat exchanger model. Several circular cross-section rods, as continuous vortex generators, have been inserted within the spiral plate heat exchanger in the cross-stream plane. The vortex generators are located at various azimuth angles of α=30◦, 60◦, 90◦, and 120◦ with non-dimensional diame...

متن کامل

Strain gradient torsional vibration analysis of micro/nano rods

Fabrication, characterization and application of micro-/nano-rods/wires are among the hottest topics in materials science and applied physics. Micro-/nano-rod-based structures and devices are developed for a wide-ranging use in various fields of micro-/nanoscience (e.g. biology, electronics, medicine, optics, optoelectronics, photonics and sensors). It is well known that the structure and prope...

متن کامل

Study of Permanent Magnet Bearings and their Stiffness

A typical passive magnetic bearing has been modeled and analyzed for its performance characteristics. The magnetic bearing studied in this work comprised of a Shaft, inner magnets sleeved over the shaft, and outer magnetic rings. A detailed analysis has been perform on the force exerted by a permanent magnet on the shaft nurture to restore the shaft to its equilibrium position when an eccentric...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 1998