Bioavailability enhancement of itraconazole-based solid dispersions produced by hot melt extrusion in the framework of the Three Rs rule.
نویسندگان
چکیده
Solid dispersion formulations made of itraconazole (ITZ) and Soluplus® (polyethylene glycol, polyvinyl acetate and polyvinylcaprolactame-based graft copolymer abbreviated SOL) were produced using hot melt extrusion. Since ITZ possesses a water solubility of less than 1ng/mL, the aim of this work was to enhance the aqueous solubility of ITZ, and thereby improve its bioavailability. The three formulations consisted of a simple SOL/ITZ amorphous solid dispersion (ASD), an optimized SOL/ITZ/AcDiSol® (super-disintegrant) ASD and an equimolar inclusion complex of ITZ in hydroxypropyl-β-cyclodextrin (substitution degree=0.63, CD) with SOL. The three formulations were compared in vitro and in vivo to the marketed product Sporanox®. The in vitro enhancement of dissolution rate was evaluated using a biphasic dissolution test. In vitro dissolution results showed that all three formulations had a higher percentage of ITZ released than Sporanox® with the following ranking: SOL/ITZ/CD>SOL/ITZ/AcDiSol®>SOL/ITZ>Sporanox®. The bioavailability of these four formulations was evaluated in rats. The bioanalytical method was optimized so that only 10μL of blood was withdrawn from the rats using specific volumetric absorptive microsampling devices. This enabled to keep the same rats during the whole study, which was in accordance with the Three Rs rules (reduction, refinement and replacement). Furthermore, this technique allowed the suppression of inter-individual variability. Higher Cmax and AUC were obtained after the administration of all three formulations compared to the levels after the use of Sporanox® as follows: SOL/ITZ/AcDiSol®>SOL/ITZ/CD>SOL/ITZ>Sporanox®. The inversion in the ranking between SOL/ITZ/CD and SOL/ITZ/AcDiSol® made impossible the establishment of an in vitro-vivo correlation. Indeed, very different release rates were obtained in vitro and in vivo for the two optimized formulations. These results suggest that ITZ would be protected inside the core of the SOL micelles even during the absorption step at the intestine, while some agents present in the intestinal fluids could displace ITZ from the hydrophobic cavity of CD by competition.
منابع مشابه
Preparation, characterization, and dissolution studies of naproxen solid dispersions using polyethylene glycol 6000 and labrafil M2130
Naproxen is a poor water soluble, non-steroidal analgesic and anti-inflammatory drug. The enhancement of oral bioavailability of poor water soluble drugs remains one of the most challenging aspects of drug development. Although salt formation, solubilization and particle size reduction have commonly been used to increase dissolution rate and thereby oral absorption and bioavailability of low wa...
متن کاملSolubility enhancement of glimperide: Development of solid dispersion by solvent melt method, characterization and dosage form development
The aim of the present work was to develop immediate release dosage form of the solid dispersion of glimperide (GLIM) for potential enhancement in the bioavailability. The solid dispersions of GLIM were prepared with PEG6000, PVP K30 and Poloxamer 188, in 1:1, 1:3 and 1:5 %w/w ratio by using solvent wetting and solvent melt method. The in vitro dissolution parameters (%DE10min, %DE30min, %DE60m...
متن کاملA Review of Hot-Melt Extrusion: Process Technology to Pharmaceutical Products
Over the last three decades industrial adaptability has allowed hot-melt extrusion (HME) to gain wide acceptance and has already established its place in the broad spectrum of manufacturing operations and pharmaceutical research developments. HME has already been demonstrated as a robust, novel technique to make solid dispersions in order to provide time controlled, modified, extended, and targ...
متن کاملPreparation, Characterization and Stability Studies of Glassy Solid Dispersions of Indomethacin using PVP and Isomalt as carriers
Objective(s) The purpose of the present study was to use the solid dispersion (SD) technique to improve the dissolution rates of indomethacin (IMC). Materials and Methods IMC solid dispersions in PVP K30 and isomalt (GALEN IQ 990) were prepared using the solvent evaporation technique and a hot melt method in weight ratios of 2, 10 and 30% (IMC:PVP). Solid dispersions and physical mixtures we...
متن کاملOrally Disintegrating Tablets Containing Melt Extruded Amorphous Solid Dispersion of Tacrolimus for Dissolution Enhancement
In order to improve the aqueous solubility and dissolution of Tacrolimus (TAC), amorphous solid dispersions of TAC were prepared by hot melt extrusion with three hydrophilic polymers, Polyvinylpyrrolidone vinyl acetate (PVP VA64), Soluplus® and Hydroxypropyl Cellulose (HPC), at a drug loading of 10% w/w. Molecular modeling was used to determine the miscibility of the drug with the carrier polym...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- European journal of pharmaceutical sciences : official journal of the European Federation for Pharmaceutical Sciences
دوره 99 شماره
صفحات -
تاریخ انتشار 2017